You talk to your car and I talk to my cat... Hummm... does you car give you as good advice as my cat gives me?
After this, It is the only voice I listen to.
** A snippet from a previous "conversation"
So, like I always do, I stopped and stared at the thing for a really long time. I'd move to the pass side of the car and look down at the stupid looking thing, then I'd move over to the driver's side, and get down on one knee and look at it some more. I must've walked back and forth between the two sides about a dozen times, all while asking myself "How was I gonna blend that transition to where it actually looked like a smooth bend, instead of some wonky attempt at a 3 point turn".
Did you ever read the Shining? ( You had to read it to get the inference here, I don't think the movie went over this that well). In the book, they talked about someone who "shines". (Basically it's having ESP) When that pain in the ass little kid was running from his drunk crazy assed dad, he mentally called the character played by Scatman Crothers to come and save them. The telepathed message was so strong, it was like it was screamed, it was so intense, it caused Scatman's nose to bleed.
So, now that that side note is set up,.......comes the rest of the story.
As I'm obsessing over how I'm gonna solve the problem with the the door/dash bar, a faint noise buzzes in my ear.
I ignore it.
A couple more switches between sides, and the noise, now definitely more of a voice, becomes more obvious. But,
I ignore it. There's nobody else in the garage but me.
I sit on my roll around thingy, and I roll between sides. Passenger side, ( I stand up) Driver side, (I kneel down. I kneel on the driver side to get a better view angle)
Then it hits me. HEY DUMB ASS! WHY DON'T YOU DO THIS?
The car is talking to me. Just like in the book, the message is so loud, I get b itch slapped off my rolly thing onto the garage floor.
It's an epiphany. I crawl to my feet, and stand with my mouth open while the car tells me that I'll have to weld the transition onto the top bar, and make a new cut at the middle of the turn. By welding the transition, I'll be able to blend the turn, I'll be able to create a butt joint where the door bar, and the dash bar will meet as opposed to the fish mouth that would just trash the paint. The butt joint could be gasket-ed, and I'd be able to cushion the bars to minimize any interference. I'll be able to make a domed cover to weld on top of the intersection that will look more like I planned it that way, Looking more like one bar instead of the two.
It's my typical SOP. Do it once, fix it twice.
Despite having a new path to follow, It's late, and I've been working on the junker for about 6 hours. I tell the car that it's late, and we'll deal with this tomorrow. No response.
Go figure.