Search results

  1. S

    Brakes Master Cylinder Question

    Hey everyone, I have a couple of questions regarding Master Cylinders. I currently have a 66' coupe A/T, 289 2 barrel, power brakes, leaky single bowl, drum brakes all around. 1. I wanted to upgrade to a dual bowl, but I was wondering if it was possible to upgrade only the cylinder part or...
  2. S

    66 Speedometer Cable Route

    Hey everybody, I've had the worst luck with my speedometer. My first cable was original but the end that goes into the speedometer got damaged when I was out on a test drive and didn't connect the speedometer. Since then I've gone through 3 cables, all of them snapping from the inside. The...
  3. S

    Part out or sell as a roller?

    If it was here on the west coast I'd most likely have a buyer for you :mad: but i'd put it around 4ish since all the body work is done; if you make it a driver i'd say maybe 2 or 3k more.
  4. S

    Part out or sell as a roller?

    Another roller vote
  5. S

    So Cal rim shops

    Hey all, on one of my other cars, a rim has developed a micro crack and is slowly releasing air, anyone know a good rim or machine shop here in socal? any help is appreciated thanks, Suki
  6. S

    Transmission Question

    Lately I've been having some problems with the transmission. The most obvious was some pretty hard shifting. This set of hard shifting tends to occur after i finish my initial trip, say from school to home, park in driveway with the engine still running then leave. When it shifts from 1st to...
  7. S

    4 Point Seat Belt without Harness Bar?

    I believe it's been done. You'd have to search around in the myriad 3 pt belt threads and you'll find it.
  8. S

    Randomnly stalls

    There's no condensation under the cap, and i pulled a spark plug to see if anything was wrong, it seemed normal, just a light grey coating but it wiped off.
  9. S

    How much sound deadening (dynamat etc) is needed?

    Anyone who did teh doors, did you take off the factory deadening? or lay it over it?
  10. S

    How much sound deadening (dynamat etc) is needed?

    I ordered 80 sq ft, and I still have a bit extra. I covered teh firewall, the floor, the trunk and behind the 1/4 panels.
  11. S

    Randomnly stalls

    Ok real quick update, i decided to take the car to the mechanic with the regular snorkel air cleaner on and on the way there it semi stalled. The engine would cut out, and the electrical as well for about 2 seconds then all of a sudden, by itself it would just turn back on then the smell would...
  12. S

    Randomnly stalls

    Is it possible to test that the switch is the problem? say for example when it does stall can i check somewhere that the switch is directly connected to? hence if there's no power at that location then for sure the switch is the problem? Where would that be? It is possible that it is the...
  13. S

    Randomnly stalls

    wires and plugs have been replaced. I'll check for condensation under the cap; I haven't messed with the timing so i'm not sure. I don't think the fuel filter was replaced when the carb was rebuilt but i'll look around to see if i can locate it. It happens at various times, sometimes...
  14. S

    Randomnly stalls

    well, the running rich was what I thought the problem was. I was thinking that the original snorkel cleaner housing was restricting a lot of air hence causing the fuel to air ratio to dip and thus killing the engine. As previously stated it did backfire once. I tried adjusting the carb to be...
  15. S

    Randomnly stalls

    I took the top off of my stock air cleaner casing (The blue snorkel) and replaced it with a piece of cardboard (ghetto i know), ever since then it hasn't stalled. As for electrical checked the battery's ground cable and it was a little loose, i put some grease in and put it back on. I also...
  16. S

    Wiring harness terminal ends

    Just my 2 cents. I also think that you should try maybe a generic harness like the EZ wire stuff. It is a learning experience when you install it. If however, you're still fixed on doing it from scratch, The main thing i'd recommend, but not necessary, is changing your fuse box to a newer set...
  17. S

    any body ever try this company and disc brake kit?

    I think the link is broken, its not working for me at least
  18. S

    It's time for new paint! Just need help with color.

    have you checked out this type of paint job? Except maybe making it silver bottom and a blue or red top; I believe someone on the forums did it on a 65 coupe, it looked sick. 1967 Mustang Fastback Rear Drivers Side View Photo
  19. S

    Aftermarket gauge quesiton

    Hey 66Runt, if you could can you post up pictures of the backside of the instrument panel; Also in terms of sending units what did you have to purchase in addition? Does it work with the stock fuel sending unit? oil sending unit? Thanks in advance
  20. S

    Suspension

    I have them on my car.