Search results

Still have mac prochamber and mufflers

i have the headunit bracket and plate for a 5.o foxbody i want to trade for 94-95 brackets

i have the headunit bracket and plate for a 5.o foxbody i want to trade for 94-95 brackets

yea mine whines just about the same i ended up putting some more sound dampening around the shifter and that helped

thanks guys i wasnt sure if it should have any whine or not thought maybe i intalled something wrong or something was out of balance thanks again

it is installed but only two back bolts is in it because i had to cut out some sheetmetal but is loose in front i will try that thanks

hey guys i just swap a t5 into my 95 gt and now under accleration it has a whinning noise that kinda sounds like a supercharger i installed a whole new clutch kit when i did the swap, the tranny was quite in my parts car so? has anyone had this thanks

hello guys i was wanting to hook up a line lock and was wondering where the best place to mount it would be anyone have a any pics thanks

yea i no everyone has said stay away from them but no one never ran them so i believe i may try it thanks guys im from keyser its close to maryland and i never have been to those racetracks hagerstown i guess is about the closest one to here

hello guys i got a 95 gt which is going to be turboed soon b&g says to use urethane motor mounts but i was planning on maybe getting soild i was woundering how ruff of a feel they give you and would it be better i have a 68 ford truck with a built 429 and urethane mounts and it isnt bad at all...

i dont have a link or anything do you have a auto parts store they should be able to get it i also had problems later not even wanting to work and there is a white bulkhead on the passanger side that always had fluid on it when i pulled the plug out it is a wiring harness in side the tranny and...

hello guys i am hooking up a air fuel gauge for a little and i was wondering which wire is the signal wire i need to hook in to on either side. while i gather up my turbo parts then i will go to the wideband thanks guys

they are a sheet metal valve cover that has been welded on the ends and bottoms that you still see. they are taller and a little larger in size i was wondering if any one has ran them to see what mods i need to do to get them to fit. im pretty sure will probably need a intake spacer but not sure...

hello i am wanting to install the fabricated valve covers but i am unsure of what i will have to do to get them fit has anyone installed them thanks

the red line in the bundle goes to the fuel regulater right can in be removed also or not

hello guys i am installing a turbo and a autometer gauge and would like to also keep my factory gauge does anyone know where i could get a oil feed block like you see with the superchargers for there feed line thanks guys

hello i am installing auto meter electric gauge and was wanting to keep my factory gauge is there any where else on the 95 gt where i can install my sender that i may have missed when i looked . i didnt think it would probably be good to tee my sender now with the new one. as for the oil...

hello im working on a turbo install and i was wondering if a 90mm granatelli will work as a blow through if not is there any things i should do to use it as drawthrough

so any 87 -95 engine would probably be just fine yes i would like to have a boss or dart block but that just cost to much. yea i was wondering if there would be any stonger blocks out there. is the 95 a roller cam i have been told it is and then some say no. how well does the supports they make...

hello i have a 95 gt and im looking for a engine to start rebuilding for a turbo setup what year blocks and heads can i use that will fit all of my stuff from 95 intake,headers, oil pan and all my asseries thanks