Question is the FMX and C6 automatic dipstick tube the same diameter where it enters the transmission.
I have a 69 with 351 Cleveland and C6 transmission the C6 is leaking around the tube. But I am using the tune from the original FMX.
thanks
Chris
I am looking for an air cleaner that will fit my 69 mustang with an avenger carb and provide hood clearance. Maybe a recessed base? What are y’all using.
Using an Original Air Ac kit to convert my 69 factory air Mustang to the new freon. Looking for pictures of hose routing especially expansion valve location.
Thanks
I am replacing the steering box on my 69 mustang . I am looking for suggestions on best option . I am considering having my rebuilt or buying an rebuilt one . I would like a direct replacement with no mods
Is anyone aware of an alignment mark on the steering wheel and steering shaft that should be matched to properly align the steering wheel spoke down. So as an example if I have 4 turns full left to full right, two tuns should should center the the front wheels. If they are not is a tie rod...
I’m my never ending quest to get my 69 mustang to drive without wandering or following the crown in the road. I have a question. Has anyone ever used a valve in the power steering line tho limit flow there by reducing sensitivity?
My 351 Cleveland has an MSD distrbuter. The lititure says it has a rev limiter and a jumper wire to connect it to a tach, which I don’t have. My question is this, does the rev limiter function, mechanically without be attached to a tach
Below is the entire harness as you can see one bulb socket has been replaced. All plugs receive flashing power but only one will connect to the signal harness. It is the other two that are in question.
The picture attached is the original harness for the scoop installed turn signals for which I have no wiring diagram. The middle plug supplies power to the harness from the left and right signal feed. And the bulbs flash as advertised. The other plugs are in question they also receive flashing...
My 69 came with a tilt/tiltaway steering wheel. The original wheel was a mess so I purchased a wheel on eBay that was better but not much. I came without a switch so I ordered one from NPD. Even though it is close to the original the lips on the switch that are designed to hold it in place are...