Issues After Installing Throttle Body 04 3.8

matt benda

New Member
Jun 11, 2015
3
0
0
hello,
i installed a bbk throttle body this morning and have been experiencing problems ever since. the check engine light is lit and the error codes i got from my tuner were the P0122 and P1000. the P0122 is something to do with the TPS( throttle positioning sensor) and the p1000 i have no clue my scanner didnt tell me. but anyway my car idles at like 850 rpm, when i give it the slightest rev at 1000 to 1200 and let off instead of returning to idle it bogs and stalls out. if i hold it at 1000 or 1200 constantly for a few seconds it begines to bog and stall, this is all in neutral btw. i have no idea where to start, i simply followed the instillation instructions off of american muscle and ran into this problem. please help.
-matt
 
  • Sponsors (?)


Disconnect the new battery cable for a few minutes and then reconnect and try again. I had this issue on my 96 GT when I installed an off H pipe and the solution for me was this. Sometimes the cars computer just needs a quick reset.

Sent from my SAMSUNG-SM-G900A using Tapatalk