Rear End Bushing?

[Zach Beeney]

I'm building a 95 mustang. I had the 8.8 sand blasted and removed the upper control arm bushing and the metal carrier that the bushing is in. Now I can't find new metal pieces anywhere. Short of going to the crappie junk yard that is close. Thanks everyone

 

[Nemethjames1]

What metal are you referring to? The control arm itself which the bushing is housed in? The torque box that's on vehicle? I don't really understand, any pictures?

 

[Zach Beeney]

On the diff housing where the uca bushing seats in theregards is a sleeve

 

[90sickfox]

Rockauto.com has them for 8 bucks...the upper control arm bushings at rear diff. You would have to drill the rubber out. Bunch of holes and a wire brush to clean the sleeve out. Guessing that this is what you need.

 

[Zach Beeney]

The bushing is out its the sleeve I haven't been able to find

 

[flstang65]

the sleeve comes part of the bushing.

 

[flstang65]

try these:

https://www.brothersperformance.com/1979-04-ford-mustang-8-8-non-irs-axle-installation-kit.html

http://www.uprproducts.com/mustang-billet-spherical-bushings-8-inch.html