Search results

  1. blown65

    347 carb...a new question...

    Prosystem's is definitely a good way to go. Patrick's customer service is one of the best IMO. If your buying a carb its only a few bucks more really to get a carb setup around your build.
  2. blown65

    347 carb...a new question...

    If you have 4.11's Id still say a 650
  3. blown65

    how hot is too hot?

    Same as said, 220 is the highest Ill go. Even though mine usually never sees above 180
  4. blown65

    347...best carb question....

    I really don't think with his setup a 750 would be faster at the strip anyways.
  5. blown65

    347...best carb question....

    650 would probably be better suited I'd think.
  6. blown65

    Replacing Flexplate on 65? Without removing engine or tranny?

    I should of added that I would just pull it out if you got it to that point. The van was a whole different kind of mess to try and get it out. LOL
  7. blown65

    Replacing Flexplate on 65? Without removing engine or tranny?

    You might be able to get it back far enough. We just did the same thing on a van of ours that needed to have it replace. Of course there was more room to move back though. Never tried it on the stang. BTW, april 1st is long gone and I doubt you fooled too many with the lame ass upside down...
  8. blown65

    H-pipe or X-pipe with Tri-Y's

    Mines loud with the race bullets but I love the xpipe on it.
  9. blown65

    Auto Meter Gauges in Stock Bezel

    Ya, it was fine with the 6al but not the digital 7.
  10. blown65

    Auto Meter Gauges in Stock Bezel

    Well, if your doing all new guages you could do the speedhut ones for the same price and smaller tach. I have the tach with shiftlight from them and it works perfectly. Not as simple as turning a knob to set the shift light, but not difficult either. I have some interference with my speedo...
  11. blown65

    Auto Meter Gauges in Stock Bezel

    LOL, don't really need a big ass tach in a fast car. Just give me a shift light. :)
  12. blown65

    Cage is in

    The swing outs were from Alston and I have to get new harnesses cause mine expired last year.
  13. blown65

    Cage is in

    The headrest unpins so I can remove it on the street. It will have some upholstery done to it to match everything else. Gotta have it with the stock seats. No its street strip deal. Shooting for 8.99 1/4 mile though. :)
  14. blown65

    UP22.com Hood

    I don't think so. Prob be ready closer to end of May.
  15. blown65

    Cage is in

    2500.00
  16. blown65

    Cage is in

    Nothing like a custom bent cage. Guy did a great job on it. Few pictures, also going back to original interior. I have the kit already, just gotta get everything covered. Door panels are staying as is though.
  17. blown65

    UP22.com Hood

    Just wait till it goes thru some cycles of heat and see how much you love it.
  18. blown65

    low compression/wide cam problem

    You can get custom cometic head gaskets that would shink those values and gain the same deal. You could also check into what that cam is made for and if you could advance it some to pick up some cranking compression / low end.
  19. blown65

    RPM Questions

    Kinda depends on piston to valve clearance.
View older results
Top Bottom
Back
Forums
Menu