Search results

  1. R.J.

    1995 GT...OBD 1or2 ??

    A picture is worth a 1000 words!
  2. R.J.

    1995 GT...OBD 1or2 ??

    There are two connectors plugged into a cover and the cover is clipped to the back of the strut tower. You can either pull the connectors down out of the cover or pull the cover off of the tower and the remove the cover from the connectors.
  3. R.J.

    transmission clunks and bangs

    +1 get it checked out (or look into it your self) to make sure there is nothing broken, then just deal with the fact that there is a lot of play. Before I could convince my self that it was normal, I rebuilt my rear end, switch to an aluminum drive shaft, replaced my clutch and changed tranni...
  4. R.J.

    1995 GT...OBD 1or2 ??

    Two connectors
  5. R.J.

    surging idle? IAC VALVE?

    is it worse with your A/C on?
  6. R.J.

    problem with idle after trickflow install????

    Did you replace the T-body with the intake?
  7. R.J.

    flex plate bolt questions... thread sealant on the bolts or not.

    +1 line up 1 way
  8. R.J.

    flex plate bolt questions... thread sealant on the bolts or not.

    loctite thread sealant
  9. R.J.

    ford racing cobra diff geaoil ?

    Does Ford now use 75w-140 in all 8.8's? I've been hearing this but nobody has confirmed it.
  10. R.J.

    ford racing cobra diff geaoil ?

    Amsoil with friction modifier
  11. R.J.

    Stalling issue - EGR?

    Updates?
  12. R.J.

    Removing EGR: quick question

    I had the same issue. Easy fix: Set it up so that it is a little to long. with the ERG valve off of the intake, screw the tube to it. now the tube it tight to the header and attached to the valve. get a hand held map gas or propane torch and heat the tube until it bends easy and slowly push...
  13. R.J.

    rear gear oil ???

    Amsoil all the way (with friction modifier). Has anybody heard that Ford now recommends 75w-140 for all 8.8's? Somebody mentioned it on a thread recently, and everybody else just agreed with no questions.
  14. R.J.

    My upper control arms are flexing and bushings ripped...Good Uppers?

    Maximum Motorsports recommends new stock uppers for any street driven 4 link combo. It's on their website.
  15. R.J.

    Tasca ford 12th Annual Mustang Show

    Go for the show but the dealership and customer service are horrible!!
  16. R.J.

    JBA or MRT

    Where did you find somebody selling a JBA catted H-pipe? How much? I was under the impression that MRT was now your only choice for a catted H-pipe for a 99-04 Gt.
  17. R.J.

    Stalling issue - EGR?

    yes it definitely would cause stalling especially when the car gets hot. A friend of mine chased this issue (hot stalling) for months after doing a TFS HCI with a new throttle body. He never set the TPS on the new T-body. As soon as I had him reset his idle and TPS the car was fine. Try...
  18. R.J.

    Ball joint?

    Check the Inner and outer tie rod ends. Also see if the play is coming from your wheel bearings.
  19. R.J.

    Quick valve covers help

    Anderson Ford Motorsport Home Page Their chrome vc's are mid height. They will clear anything and fit under your setup. Oh yeah they are only $80
  20. R.J.

    Stalling issue - EGR?

    Did you reset your TPS after adjusting the idle?
Top Bottom
Back
Forums
Menu