Search results

  1. 4

    Stock Rims Tire Upgrade

    I disagree. Looking at the picture, it is pretty much what I am making it out to be. You have a tire almost three inches wider than your wheel. If you cannot imagine it being an issue, why did you stop at 275's? Why not 315's? Is there a point where you think there might be a potential...
  2. 4

    Missing Under Load @ Low Rpm's

    Why were the COPs changed? Did you replace them with the factory COPs or with aftermarket pieces? The reason I ask is in my experience a bad COP is the reason for misses. I cannot imagine a scenario where every COP is bad and they all need replacing. If you replaced the COPs with...
  3. 4

    New To Mustangs, Help Needed

    How many miles are on the car? I'd suggest changing the spark plugs, oil, and air, fuel, & oil filters regardless given the age of the vehicle. The PO isn't going to do it prior to a sale. The reason the word "NORMAL" is written on the gauge is because the needle is normally within that range...
  4. 4

    Stock Rims Tire Upgrade

    FYUI, a 275 is a lot wider than a 245. It's 10.8 inches vs. 9.6 inches. IOW, over an inch difference. And a 245 is pretty much the widest you can fit on an 8" wheel. You might be able to find a shop to mount a 275 on an 8" wheel, but that's just dumb. You really want at least a 9" wheel...
  5. 4

    Brakes Dont Work As Good After Brake Job

    If they are factory replacement pads they're fine. Your rotor is thinner so it takes more pedal travel to apply the same pressure. Mine were the same way after turning the rotor. Replacing the rotor gave me back the brakes the car came with.
  6. 4

    Brakes Squeek When Not Pressed And It Goes Away When They Are Applied

    Pads rub on the rotor all the time. There shouldn't be any pressure, but they will rub. I've not done it, but what you could do is remove the pads and file a bevel into the leading edge to see if that helps. I had my brakes done at a private shop a month ago and they squealed like hell when...
  7. 4

    Low End Upgrades To A 4.6?? Help!

    The 4.6, especially the 99+ PI engines, is a different kind of powerplant than the old 5.0. It's a high rpm screamer, not a low-end stump puller. Wind it up to 6 grand, preferably while going through a tunnel or underpass. Torque peak is at 4000 rpms, power starts coming on at ~3000 rpms...
  8. 4

    Speedometer Reading Low On Stock 03 Gt

    Sounds like the replacement rear axle came out of a car with a taller rear gear than the factory 3.27 that came in all '03's. Based on your first post, I'd guess you have 2.73's. You could try disconnecting the battery for half an hour, but I can't see any scenario where that will solve your...
  9. 4

    New Shocks And Struts. Yet, Drive Is As Horrible.

    What is "BMW quality"? Please elaborate. Stiff shocks and struts can make the ride harsh, but so can stiff springs. I think replacing the springs is a good idea.
  10. 4

    Check This B.s. Out!

    If someone is dumb enough to send money for a car sight unseen, I'm not sure how much sympathy I feel. I wouldn't be to worried about other people possibly breaking the law by scamming someone - it's not like interfering now is going to stop them. But yeah, do what you can to get the ad...
  11. 4

    Geting Butt Kicked By Z28!?

    Why do people act surprised when a car with a 100 hp advantage smokes them? WTF did they think was going to happen?!?
  12. 4

    Oil change time for my new 02 GT, time vs mileage on oil changes?

    I've always just used a Motorcraft filter and Motorcraft synthetic blend 5W30. Never seen any convincing evidence to use Mobil 1. Even more so if you aren't even driving the car.
  13. 4

    How much power am I losing?

    I've got a turbo impeller/compressor and housing from a GM diesel sitting in my living room behind my couch because I don't have a garage. After reading this thread I'm going to put it in my trunk so when the OP rolls up alongside and asks "Whatcha got?" I can say "Big-ass turbo" and win the...
  14. 4

    1998 GT What engine should i put in?

    http://www.vincelewis.net/bigengine.html
  15. 4

    Just bought a new CLEAN 2001 silver Mustang GT and have a few general ?'s

    They don't "suck" just some people experienced some isues with grinding going into 2nd on really cold mornings. Apparently there was a TSB to address the issue in such cases. Any time a model is this popular, there are going to be people who exaggerate the significance of any possible issue...
  16. 4

    01 GT After changing spark plugs and coil packs, car started ticking/knocking, now it wont run.

    ^this. And aftermarket COPs and coil packs are inferior to factory parts. Accel coil packs and COPs are garbage compared to Ford replacements. Put the stockers back on and have a dealer test them to see if one is causeing an issue. If so, replace it with a Ford part, not crappy aftermarket...
  17. 4

    Sticking Gas Pedal

    I try to lube the throttle cable at least every year. Some oil on every linkage and a little down the sleeve helps a lot. You can use WD-40 or JB-80 to free it up initially but you need to follow it up with 3-in-1 or a couple drops of motor oil, as spray oils evaporate leaving little to no...
  18. 4

    Yet another ? from me...

    14.2 in mid-August in my stock '99 GT 5 speed, just lowered the rear tires to 24 psi. Track was greasy and it was my second time at a strip ever. Get better traction at stoplights than I did that day at the track. Headers, mid-pipe, exhaust and tune will get you mid-13's on an otherwise...
  19. 4

    F*****g hail

    I disagree. Get it all fixed. There's nothing more ghetto than getting an insurance claim and spending the money on beer instead of fixing the car. In my experience, body shops often do extra minor work as long as the bill is being covered by an insurance company. Not saying they'll...
  20. 4

    I just bought Projectors, I hope they don't look Terrible

    This. Factory Mustang headlights are actually fantastic. You probably bought a car with old bulbs and dirty yellowed lenses. Good luck with your tinted ebay lights :/ You'd be better off replacing your current fogged housings with factory pieces or at least cleaning them up and buying new...