Search results

  1. dcurtis

    Tire Size Without Rolling Fender

    Shouldn't have to roll with that size so long as you get a 15X8 with the 5.5 bs. I'm running 245/60-15 with that backspace and width no problem other than an occasional rub on the inner wheel well, tires actually measure 27.1 x 10.2, I've got a good half to 3/4 inch before the fender will hit
  2. dcurtis

    Odd Firing Problem

    Thanks to the rain I just got around to re installing the computer, only change is that the random flashing check engine light now stays off, still an obvious miss though, there's also a second or so hesitation when hitting the go pedal, I'm lost at this moment, guess I'll pay someone to trace...
  3. dcurtis

    Odd Firing Problem

    Pip is inside the distributor right? I have swapped the distributor out with two others with the same problem, back to the original in the car at this time, I'll have the computer fixed and go from there, hope that's all.
  4. dcurtis

    Odd Firing Problem

    Entire engine is new and was potent as hell, then a random mis I cannot track?
  5. dcurtis

    Odd Firing Problem

    Could or would that being bad cause a firing condition?
  6. dcurtis

    Odd Firing Problem

    It wasn't swollen or anything, looks more like one side just corroded, green and just rotted out like a bad battery cable looks
  7. dcurtis

    Odd Firing Problem

    I know what it is, I have the replacement for it already, gonna put it in tomorrow, just curious if it could be causing my firing issue or what it has to do with in the comp
  8. dcurtis

    Odd Firing Problem

    May have found the problem, hopefully, I'll post a pic of te computer, anyone know what this piece is called and it does?
  9. dcurtis

    Odd Firing Problem

    Well, that was obviously not the problem, it started missing about a mile into my drive to work, got her home after work and just out of curiosity shook the salt pepper shaker and idle jumped up a few hundred rpms instantly, tried it again to see which connector was causing it and it died and...
  10. dcurtis

    Suspension Front Sway Bar/stabilizer Bar Bushing Brackets

    Every thing I've read says 27 mm, is it factory or aftermarket
  11. dcurtis

    Odd Firing Problem

    Well checked way to many things so far, finally just swapped the brand new msd coil for a factory one and problem cleared up for now, didn't drive far but we'll see tomorrow when I try to drive to work
  12. dcurtis

    Timing Issues Help/advice

    I've had that problem before, just pulled it out and stabbed it about 2 teeth farther
  13. dcurtis

    Timing Issues Help/advice

    Basically to get the timing you want, you can't cause the tfi module hits the radiator hose
  14. dcurtis

    Setting Valve Lash/preload On Tfs Heads.......1/2,3/4, Or 1 Full Turn

    I always run at least 3/4 turn, my new engine revs well above 6500 now so I go 1 full turn
  15. dcurtis

    Odd Firing Problem

    Timing at 14 degrees without spout connected
  16. dcurtis

    Odd Firing Problem

    Engine is a sportsman block, all forged 347 bottom end, tfs heads, rpm2 intake, 75mm maf, 70mm throttle body, 30lb injectors, afm n51hr cam, msd 6al2, msd blaster coil and a 190lph fuel pump
  17. dcurtis

    Odd Firing Problem

    Used an infrared gun to check header temp, 2 cylinders were about 50 higher than the rest which were at around 320-340 range, I did add 4 psi to the fuel pressure but the problem was already there, I added the pressure cause the plugs looked new after driving for two weeks
  18. dcurtis

    Odd Firing Problem

    Ran koer codes, got 94 44 31 and 13, cylinder balance test was a 9? Swapped in a known good distributor and it actually seemed better, until I hit the road, within feet I could tell it was missing still??? I'm out of ideas, could the computer be bad?
  19. dcurtis

    Odd Firing Problem

    I've bypassed the msd to clear it as a problem already, could it be in the distributor or computer?
  20. dcurtis

    Odd Firing Problem

    So to start I've been having an occasional miss, the other day the miss became permanent, what's new, msd 6al2, msd 8.5 wires, plugs, cap, rotor and tif module, the problem is that I was using a timing light to see what plug wasn't firing, all are, just that the entire drivers side is firing...
Top Bottom
Back
Forums
Menu