Search results

  1. mo_dingo

    What cable goes to starter??

    ^ yup, exactly right
  2. mo_dingo

    I'm at a loss

    I have a foot long 3/8" ratchet that has a flex head with the O2 socket. It seemed to do the trick. I do believe I had to hit the end of the ratchet with a hammer to initially break it loose. Kind of a pseudo-impact wrench but it worked. Scott
  3. mo_dingo

    Bad fuel pump?

    It definitely has something to do with the fuel pump. It may be the pickup, but you won't know until you drop the tank. Run the mustang until you run out of gas, drop the tank and see what's going on. Scott
  4. mo_dingo

    GAS IS UP AGAIN! RANT Thread, WHO's FAULT IS IT?

    Until we stop buying gas, the prices will never fall. They will always increase every year, not-stop. We will buy it if it costs $5 or $100/gallon. If the demand never drops, the price always increase!!!! The only solution is hydrogen fuel cells. Once our cars can convert water to hydrogen, we...
  5. mo_dingo

    Dyno disappointment!!

    This is the whole reason why I would never let someone tune my car. They are just shrugging their shoulders, pointing their fingers elsewhere and trying to BS their way through it. I hope you paid with a credit card. You may be able to cancel payment, and promise re-payment once they fix the...
  6. mo_dingo

    94 Mustang Side View Mirror Options?

    But for $25 it's not a bad deal. I would get them, sand them and paint them gloss black. Maybe even bondo over the LED BS and paint....:shrug: Scott
  7. mo_dingo

    Vacume hose from valve cover to CAI, do i need it???

    many do a breather and that is what I would do. Scott
  8. mo_dingo

    Dyno disappointment!!

    Yeah your a/f should be around 13 - 13.5 all the way through. The spark curve may not be correct either. Not a very good dyno tune IMHO. Scott
  9. mo_dingo

    mustangsunlimited.com H-pipe

    Yeah I would stay away from it, as well as the summit h-pipe. Get a good one piece h-pipe and be done with it. Scott
  10. mo_dingo

    Does this sound right?

    You need to have your a/f ratio checked out. You may be running super rich or lean. Have you performed a cylinder balance test to make sure all 8 are firing equally? Scott
  11. mo_dingo

    a/c blowing warm

    You have not jumped the low pressure switch.
  12. mo_dingo

    Idle Air Control

    datalog with the tweecer and log your injector PW at idle on both banks. Scott
  13. mo_dingo

    Would gears make a clunking sound like almost a month after install?

    Yup, sounds like a typical u-joint problem. Next check rear suspension, then motor/trans mounts. Scott
  14. mo_dingo

    Battery woes

    Well most car batteries are 100amp/hr rated. and if you have a 1amp draw, in 100 hours or ~4 days, it will be dead. So it doesn't take much of a draw to kill your battery. I would take a amp clamp and see how much is being drawn off of the battery cable. If it's under .2 amps, then I wouldn't...
  15. mo_dingo

    a/c blowing warm

    You need to remove the plug for the low pressure sensor and put a jumper wire in it's place. That will make the compressor run non-stop, and you fill it until you get to 35 or so. Scott
  16. mo_dingo

    A/C line valve leaks, any suggestions?

    It's a tapered thread inside the high or low pressure valve. A 5/16-24 bolt will screw in, but it isn't tapered thread & won't seal. I can't remember what size it is, assuming 5/16NPT or something like that? Scott
  17. mo_dingo

    No Injector pulse

    Go to the tuning section. They have a lot of good info to get you up and tweecing. The best thing I have ever invested in was the innovative wideband O2 sensor. It just makes tuning so much more accurate; I stopped pulling my hair out!!! Scott
  18. mo_dingo

    what do short pushrods sound like

    If a pushrod is too short and hits the rocker arm, and no one is around to hear it, does it make a sound?
  19. mo_dingo

    started taking off my heads....

    Did you drain the coolant when completely before you started????
  20. mo_dingo

    Little help please - passenger side accessory bracket

    Just make sure you use grade 8 hardware and you will be fine. Scott
Top Bottom
Back
Forums
Menu