Search results

  1. R

    1991 331 stroker trick flow, will not run good

    re After installing the new ignition module that cleared up the cracking and poping. The car is now starting to idle and run somewhat normal, it wants to rev to around 3000 rpm and stay there at times by its self, the headers are also getting quite hot. It seems the intake is pulling air from...
  2. R

    1991 331 stroker trick flow, will not run good

    once again Ok again tonight I went back in, readjusted the valves to make sure adjustment was correct, checked timing, found compression stroke, pulled TDC with a piston stop and the balancer was 1/16 on an inch from the 0 degree mark so close enough. dropped the distributor in pointing right...
  3. R

    1991 331 stroker trick flow, will not run good

    re Tonight after going back through everything double checking valve adjustment, timing, finding TDC etc etc we finally got the motor to crank but it has a terrible pop and cracking, also seems to be poping back through the intake, I have considered the possibility of the MSD 6AL box giving...
  4. R

    1991 331 stroker trick flow, will not run good

    RE Tonight we try it again, I am not 100% sure the keyway is off. I am sure that there is something serious going on, the car at TDC ,10 degree timing, chip out of the distributor will not crank and turns over slowly as if the timing were advanced. This was an issue before the cam change, the...
  5. R

    1991 331 stroker trick flow, will not run good

    re pissed pardon the language but boy i am mad We put the new cam in went through the motor and timed it tried to fire it and nothing, I suspected timing issues before the cam change and was told because of the x cam it was related to to computer, well now tells the tell. for the second time...
  6. R

    1991 331 stroker trick flow, will not run good

    900 to 1000 and the fuel will burn your eyes its bad but then you drive the car and it leans out
  7. R

    1991 331 stroker trick flow, will not run good

    re my engine is running is running rich at idle so rich is smells like raw fuel but above idle it runs lean the plugs are semi white.
  8. R

    1991 331 stroker trick flow, will not run good

    Good advice, I would like your input on my thinking about the Cam swap, The X-cam seems to make more high end horsepower, even some that is un-useable with a stock rev limiter, my thoughts were that number one the trick flow cam would be better matched to the heads/intake I have and would have...
  9. R

    1991 331 stroker trick flow, will not run good

    Guys, Hi and great forum! I have a 1991 Mustang that has the following mods: 331 DSS stroker Trick flow street heat heads 1.6 roller rockers trick flow R series intake 70 MM throttle body & C&L 70 MM Mass air X-303 cam BBK full length headers off road x pipe flowmaster exhaust...
View older results
Top Bottom
Back
Forums
Menu