Search results

  1. V

    Wheel Fell Off During Test Drive

    that guy is a complete idiot..all that stuff he was telling you was a load of crap. He forgot to tighten the wheel, plain and simple...Expect to replace the axle at a minimum, maybe even a bent 8.8 rear housing...I too would pass on the car.
  2. V

    Looking For Help With A 91 Code

    Like he mentioned, swap the o2 sensors...I don't care how sure you are that they're good, if you haven't swapped them yet, then do it. If it's not that, it's a vacuum leak, or an exhaust leak before the o2 sensor
  3. V

    Engine Carbureted Intake Advice

    not sure if you'll notice much power difference from an intake swap without swapping the heads too...the factory ford intake is an aluminum unit that I've heard is very similar to an early edelbrock piece... However I've had a lot of luck with the weiand stealth intakes. The street avengers...
  4. V

    1965 Fastback

    Yea, the hydraulic lines go into it. Power steering conversion is no cheap thing, you essentially have to redo the entire front end
  5. V

    Electrical New Fog Lights Won't Turn On

    they're blue where the harness exits the firewall under the hood dr side
  6. V

    1965 Fastback

    don't forget the steering box too... I have the same issue..my stang is uncontrollable without power steering,..too much power and it's impossible to counter steer a rear slide.. I'm going to the rack and pinion route, no way I'm spending that amount of cash on just another steering box conversion
  7. V

    Drivetrain Dumb Question: Transmission Fluid

    dextron mercon atf...and synth atf is just wasting cash. pull the top fill plug, pull the shifter, fill through the shifter hole till it leaks out the top fill plug. tightening the bell to trans or bell to block bolts will do absolutely nothing. If it's leaking out at the bell housing, and...
  8. V

    Engine Help With Never Ending Hessitation/bad Idle Problem I Cant Figure Out...

    So you've been throwing parts at it, and haven't pulled codes yet? You can't even begin to troubleshoot a computer controlled vehicle without pulling codes first. Even if the light isn't on, a code can still be stored. Try running koeo and koer codes
  9. V

    Drivetrain Transmission Fluid Change

    completely unnecessary. Run dextron mercon non synthetic atf. Typically gear engagement issues is a clutch adjustment
  10. V

    Water Pump 86-93 Vs Timing Cover 94-95

    get the correct timing cover, the accessory brackets, wp, timing cover, everything is different for 94/95
  11. V

    Steering Column Moves Up/down

    I'm not sure what that bracket is from the picture, but it's directly below the quadrant, so there is a good chance it's your problem. FYI, the steering column bolts to the clutch pedal assembly, then to the brake booster at the firewall. If you're having issues with clutch engagement and...
  12. V

    Solid Rear Diff Cover

    I've got a mac cover with what I "believe" are cap supports...they're a threaded set of bolts in the cover...how to I adjust/use them?
  13. V

    Electrical New Fog Lights Won't Turn On

    typically when the fox foglights go out, it's the fuseable link dr side out of the main harness, or the relay itself under the dash. If you want them to come on with the headlights, wire a relay into the headlights, and to the the foxlights
  14. V

    Help With Bell Housing And T5

    the sn95 bell and t5 are a mated pair, the input shaft is longer on the t5. When you use a fox bellhousing, you also must swap out the input shaft on the sn95 t5 to the shorter fox style too.
  15. V

    Proform Pedestal Mount 1.7rr Questions

    when my friends pro form rocker went south, it slipped off, got a chunk gnawed off by the valve spring, sent metal shaving through his entire 347, destroyed the block...cylinder walls, crankshaft, everything was scratched and destroyed...Don't cut corners when building a car.
  16. V

    92 Won't Start, Stuck In Gear

    Sounds like a,great honest shop, those plates are cheap, shouldn't set u back much
  17. V

    Smoother Riding Fox?

    4 cyl springs and swaybars
  18. V

    Another Egr Question

    Without those egr holes in the intake, egr isn't working...at this point pull the egr off and Ditch it
  19. V

    Gm Motors In Mustangs!!!

    Chevys been building crap bodies since the 80s.. The fox mustang is the perfect and cheap platform for hot rodding... Ford's newer motors are way too big to be able to stuff into an older ford for a reasonable price... The Chevy LS motors and Dodge Hemi motors are the nice perfect width to use...
  20. V

    Late Model Engine In 69

    You will see no performance gains in using a 4.6 or 5 .4... For your car 351 the best route
Top Bottom
Back
Forums
Menu