Search results

  1. MustangPunk302

    What causes inner front tire wear??/

    Caster/Camber plates, they allow you to/more adjustment with camber and caster. The stock strut towers do not have provisions for correct adjustment usually and caster/camber plates allow this. A good alignment tech, can usually make the adjustment without the plates, but the cost can be the...
  2. MustangPunk302

    Help me identifty my EFI harness

    Err... excuse me, I mean connectors...:D
  3. MustangPunk302

    Help me identifty my EFI harness

    What are the color's of the wires going into the two sensors?
  4. MustangPunk302

    Help me identifty my EFI harness

    Well you said there was a MAF connector, so like you said we know it's 89+... This is gonna be fun :P, any part numbers on the ECM connector? P.S. what you gonna do with that 600? :P
  5. MustangPunk302

    ported stock heads with speed density?

    Uninformed or under imformed :P... You'll be fine, bud..
  6. MustangPunk302

    smog question

    If they're lower the only reason is because of restriction from the cats and the air pumps drag. (i.e. that's why people take it off) The actual EGR (I've had many debates about this one), and thermactor system won't hurt performance.
  7. MustangPunk302

    Car does not start ocassionally?? Starter?

    Now when the starter does go, it turns the engine over no problem? I mean it doesn't sound like a starter problem, if it finally goes no problem. The problem sounds like the starter solenoid not getting enough power from the ignition switch. You checked you check for loose connection's at the...
  8. MustangPunk302

    uuuuuuuugggggghhhhh! hazards work but turn signals dont? WTF?

    Bull****... :P Yeah, your right, they're those stupid tamperproof ones though.. :nonono:
  9. MustangPunk302

    What causes inner front tire wear??/

    Excessive toe-in will cause a saw-tooth wear pattern, the edges of the tread would be pointing to the center of the car, and out from the car if a toe-out problem was the case. His problem is most likely negative camber, as stated.
  10. MustangPunk302

    AFR and rocker arms....

    I haven't had problems with my stock studs on my 185's. They're upgraded by simply taking the 3/8" out and putting in a set of 7/16". I tried to look up the specs on comps website but it said to call 1-800-999-0853, so call em up and get there advice. The stock afr springs should work if it...
  11. MustangPunk302

    B303 Cam

    Anyone tell me the specs of this cam, including IVO, IVC, EVO, and EVC. Thanks...
  12. MustangPunk302

    no traction through first and crazy sideways in second

    Mine does the same thing with street tires, as an modded 5.0 Mustang should.. Granny it into second... If you really wanna lay some rubber hit third hard when it's screaming through second... :p
  13. MustangPunk302

    Help..Who has a Holley Carb on there Heads and Cam 302's?

    My stock 85 GT save for Edel Performer and full exhaust, has got a S/P 750 on it, I had to rejet the mains, got sick of fouling plugs out and looking like a goddamn diesel lmao... I believe I put #69's in it, she's a tad rich at idle but she runs like a champ when you let her eat..
  14. MustangPunk302

    11:1+ Compression on Pump gas?

    My civic has 12:1 and the mustang is about 13:1 and I run both on 93 octance... Though the mustang takes full advantage of 100+ of cousre :nice:. You shouldn't have any troubles.
  15. MustangPunk302

    Retraction: Mustangwarehouse.com

    http://www.jdsperformance.com Anyday... I bought my 185's from them, free shipping too, Dave is the best.. :nice: Plan to purchase many more parts from him.
  16. MustangPunk302

    Completly stock motor vs. Balanced and blueprinted stock motor? How much HP gain?

    To actually get power from a fully balanced shortblock you'll run looser tolerances in the main and rod bearings. Though of cousre if you go to loose, you trade improved oil flow for loss in pressure. I'm not saying pressure is better then flow, you have to have both in the proper proportions...
  17. MustangPunk302

    '05 Mustang's spotted on I-96 East

    West of Lansing, before the junction, probably 5-10 miles, I'm certain they kept going east towards Detroit of cousre...
  18. MustangPunk302

    '05 Mustang's spotted on I-96 East

    This happened Sunday night btw. I was on my way to Nashville, and couldn't post till I got back.
  19. MustangPunk302

    '05 Mustang's spotted on I-96 East

    I wasnt paying attention and I passed one. Then it hit me. "WTF '05 MUSTANG!" There where about 10 2005 Mustangs going east on I-96... There was a few more GT's then base models , like 7 GT's and 3 base models.. I was over come with excitement though to pay to much attention... I was in my '91...
  20. MustangPunk302

    Can someone tell me what my combo will run and hp its making

    Yes...
Top Bottom
Back
Forums
Menu