Search results

  1. P

    FS Wings West '93 Cobra Kit

    FS Wings West '93 Cobra ground effects Kit I have a wings west 93 cobra spoiler kit f/s. The kit has the front spoiler, side skirts and rear valance. The kit is made of polyurethane so it flexes. Never installed and it has screws and 3m tape included for installation. This kit has never been...
  2. P

    Selecting cam for stock bottom end, good OTS?

    The bottom end is stock. I'm using a xe276cam (224/230-112). BBK long tube headers. My build is similar to Ricks's 302. 75mm tb,4inch power pipe. When I was doing the motor, I almost fell into the holley is too big trap. But after doing some research, I took the gamble. I dont have track...
  3. P

    Pro-comp Heads?

    Garbage..After spend money cleaning up the ports and checking the hardware.Thats money that could've been spent on a better head..
  4. P

    Selecting cam for stock bottom end, good OTS?

    I knew I should of went with a smaller intake...:shrug:
  5. P

    Getting close and getting nervous am I forgetting anything?

    If the guides look good the shop wont do it to save you money. Atleast thats what the machine shop did that worked on my heads. If you can get Ford parts I would use them. I had good luck with some gt40 heads I had. I put alittle too much money in them but they worked ok.
  6. P

    New DD picture!!!

    I had a 96 escort gt 2years ago. I put a Gude performance package on mine (cams,ported intake, ported throttlebody and ported head) I also had a pacesetter header and catback on the car. It made 145 hp on the dyno and ran 15.0's @ 94 mph in the 1/4. Gas mileage was still around 30mpg and it...
  7. P

    Selecting cam for stock bottom end, good OTS?

    I ran the xe270hr114 cam in a gt40 motor I had. The car made 315 hp and ran 7.80's @ 89 in the 1/8. In my current 93gt I'm running a xe276 with a systemax topend and brodix heads. My car made 358hp with that cam. The xe270 is a good street cam, it peaked at 5500 rpms for me. The xe276 peaks...
  8. P

    Mass Air and Throttle Body??????

    To do the upper intake it was around 400.00 It's not cheap by no means. The hp per dollar ratio doesn't look good either if you just focus on that one part of the combo. But I think with a properly ported lower and a good cam, heads. The Extrude Hone work could be the difference in winning a...
  9. P

    Mass Air and Throttle Body??????

    75mm tb and 80mm MAF ofcourse On my 93 gt I'm running a stock bottom end with fox lake ported brodix heads (187 cc).. I'm hoping the car puts down atleast 340hp to the ground on the dyno.
  10. P

    New combo running rich

    No way will you get that car to idle good and have decent drivability with that cam in a SD car. The problem your having is too low vacuum with a cam that has less than 114 LSA.
View older results
Top Bottom
Back
Forums
Menu