Search results

  1. A

    351 victor jr under 66 shelby hood?

    I am building a 351 becasue I want the biggest motor possible in my car. I wanted a 351 and shopped around and noticed that CHP has a 393 short block for 2100. I figured that would be just fine for my mustang, it is now comming close to the order date and I want to get everything ready for when...
  2. A

    351 victor jr under 66 shelby hood?

    Ok , the victor is out, anyone have experence with the torker? That is the lowest open plenum intake I could find and the measurements printed in PAW make it shorter than the RPM
  3. A

    351 victor jr under 66 shelby hood?

    what kinda carb and how many inchs drop? I know the torker will fit, but it is kinda gay, not to offend any homo's out there.
  4. A

    351 victor jr under 66 shelby hood?

    Anyone know if a 351 with a Victor Jr will fit under the hood of a 66 with a fiberglass shelby style hood? Is there a way to mesure without actually putiing in the motor? I would have to order the rpm or the victor jr and I don't want to be stuck with a hood that will not close. Thank you.
  5. A

    ? about problems for 351 in 66

    Thanks all, P.S. ANyone know a good shop in the sacramento area?
  6. A

    ? about problems for 351 in 66

    Anyone else? What about a remanfactured block, I saw one from PAW for like 200. Anyone have any experiance with them?
  7. A

    ? about problems for 351 in 66

    I am trying to decide what type of motor to build for my 66. I was looking at the 331 stroker kit from CHP and I noticed that the 383 kit based on the 351 is the same cost, so I figure, go for the bigger motor. I know some people have 351’s in their 65-66 mustangs and I want to know how hard...
  8. A

    302 vs 5.0 ?!?!? HELP!!

    Thanks for the replies.. I am not going to go EFI in my car. I know it would be a lot for me to handle and I am going to stay with old fashion carburetion, no matter what block I use. I like it and there is no reason to change. I don’t know how to read the codes on my heads so any help...
  9. A

    302 vs 5.0 ?!?!? HELP!!

    Hello, I have a few questions about building my first motor. I have seen stroker kits online and I like the ones from Speed-O-Motive. Has anyone bought from them before? How did you like it? Can you recommend any machine shops in the Sacramento, CA area? I have a 66 with a 4 speed and...
  10. A

    Will a 67 dual resevoir mast. cyl. work in 66 single resevoir mast. cyl.?

    I have a 66 mustang with manual front disks and rear drums and a duel reservoir master cylinder. I bought it that way and have no idea where the master is from. Anyone know if there is a way to add a power booster to my car?
View older results
Top Bottom
Back
Forums
Menu