Search results

  1. IApony

    Overspray

    I agree razor blade or clay bar.
  2. IApony

    Help with front bumper cover body work?

    Your best bet is going to be to strip down to the bare bumper( with sand paper or urethane same stripper. Next you need to clean it very well. If there is deep scratches or nicks in the cover you can buy flexible filler. Then use a adhesive promoter and flexible primer.:D
  3. IApony

    Spark plugs E3

    Anybody running the E3 spark plugs and if so whats your opion.:D
  4. IApony

    tranny problems..

    If it still has the factory clutch quadrant it may have broke. Especially if it has a stiff aftermarket clutch.
  5. IApony

    Painting LX side moldings

    I would recommend using an adhesive promoter prior to laying down the paint. What kind of paint are you going to use.
  6. IApony

    plug wires

    you guessed it, there cracking in half then arcing onto the header.
  7. IApony

    plug wires

    He has them seperated fine. It is just the boots that keep falling apart due to the heat and a little oil on them sometimes.
  8. IApony

    plug wires

    I have a buddy running a 306 w/alum heads,vortech,and equal length shorty headers. He has a problem with plug wires not lasting very long. I was wondering if anybody could reccomend a good set that will take the heat better.
  9. IApony

    I need advice on paint products

    The nason clear has nice shine and is durable, it may not have quite the DOI of some of the high end paints.
  10. IApony

    I need advice on paint products

    It covers pretty well I seal all of my stuff first.
  11. IApony

    I need advice on paint products

    I have used the dupont/nason products the last 5 years on my own vechiles and customer cars. I have had no problems and good durability.
  12. IApony

    Idle/Rev Clips Post 'em Up!

    short clip in the garage YouTube - MOV01364
  13. IApony

    Exhaust Clip Mega Thread

    heres a short clip of mine YouTube - MOV01364
  14. IApony

    Need a tune IA

    I'm only 2 hours from Des moines I'll try and look them up thanks
  15. IApony

    What kinda spray paint cobra insert?

    Just check with your local body shop, it should only take about 1/4 pint of base + the clear shouln't cost to much. The good old fizz can will look terrible.
  16. IApony

    Need a tune IA

    I have been helping a buddy with his sc 306 mustang, and he needs to get a tune. I live in southeast iowa does anybody know the nearest place to get this done. thanks
  17. IApony

    vortech

    I pretty sure his is a s trim running low boost and it does have the fmu. I know it also has a different throttle body and maf, I will have him check and see what they are.
  18. IApony

    vortech

    I guess he might have an issue because I think he is running 24lb injectors. He bought this car with all of this stuff on it and were trying to fix the issues. Agian thanks for all the help.:D
  19. IApony

    vortech

    thanks for the input. I will have to see what injectors he is using , I know it has the cobra intake, the alum heads ,and a cam
  20. IApony

    vortech

    I am helping a buddy work on his 91 with 306 alum heads and vortech. I was curious if it neccesary to run the trex pump if he already has a 255lph pump in the tank. thanks
Top Bottom
Back
Forums
Menu