Search results

  1. S

    96 cobra front brake pad hardware

    i have a weird noise from front pads while driving. more like a clunking noise, i removed pads, everything looks normal, only hardware was 1 pin, 1 washer and 1 clip, same on other side. put all back together, noise got worse, i am not sure if i'm missing any additional hardware! thanks guys
  2. S

    96 cobra high idle

    i just purchased a 96 cobra, after 1 week, i decided to work on car, i found the harness disconnected for the iac valve. i connected harness, then car started to idle at 2500-3000 rom for about 45 seconds, then drop down to normal, then it would raise right back up, then drop.. then i...
  3. S

    96 cobra rear end?

    it has been wrecked, but only a broken axle from what the previous owner had told me! his son got a dui,crashed and broke the axle, i looked an looks like new control arms, just lower, i havn't got the car on a lift yet! i will within this week.. hopefully its something simple.. the car does...
  4. S

    96 cobra rear end?

    i just purchased a 1996 cobra coupe! i noticed that the left side rear tire sticks out more than the right side, also my tire rubs on the left side? is this a common issue with these cars because i've seen a few with the same issue! does anyone know the fix? my tire size is 255/40/18 thanks...
  5. S

    No start, no crank, no click from starter

    you probally have a bad starter solenoid
  6. S

    94 Stang GT Going crazy in the cold

    its your starter solenoid sticking, the burning smell is the wire getting SUPER hot! change the starter, cable and solenoid......... cold weather usually causes old starters to go bad!!
  7. S

    Post pics: ***lazer RED 94-98 GTs**

    those pictures were taken in san francisco @ the high dive.... and the fox coupe is sitting on 20's.. its a feamale who owns that car
  8. S

    Post pics: ***lazer RED 94-98 GTs**

    here is mine.. just got it a few months ago and still working on it
  9. S

    1/4 window replacement

    i tried to move forward as much as i could,
  10. S

    1/4 window replacement

    yes it came off a convt. i lifted the window higher, but it looks like water would get in from the door, the rubber is barely hugging the front window
  11. S

    1/4 window replacement

    i have a 94 gt convt, i just bought a used glass off a 98 mustang, installed new glass and i was not able to get the window flushed against the convt top, there was a gap from the 1/4 window to the top, was a small gap but water can enter, i adjusted the window, regulator and still no...
  12. S

    94 GT smog pump?

    other than getting noisy, how can you tell if your smog pump is going bad?
  13. S

    94 GT smog pump?

    its the chilton's 94-98 mustang repair manual
  14. S

    94 GT smog pump?

    hmm.. kind of wierd, i never removed it but it says in the repair manual, there is a EAP electric air pump.
  15. S

    94 GT smog pump?

    i have a quesion about my smog pump. is it electrical? i was reading the repair manual and it says its is electrical but i dont remember seeing a connector when i had the entire mounting bracket disassembled
  16. S

    What are these lines

    the green 1 goes to the egr valvethe red one goes to intake for vacuum, gray and orange goes to the valves for the smog pump. that is how its on my 94
  17. S

    Clogged Charcoal Canister

    how can you tell your canister is bad? kind of wierd but i have no pressure at all when i release the gas cap, i justed repaired a cracked hose on the canister but still no pressure, is it possible my canister is bad?
  18. S

    thermactor system

    where is the vacuum supposed to be at? im not sure if im reading it right but it was .5
  19. S

    thermactor system

    how to i check to see how much vacuum im pulling....
  20. S

    thermactor system

    i did repair the lines, but there still a surging idle! do you think the solenoid can cause that? i was reading the manual and it said to test the solenoid, apply 9-14 DC volts to solenoid terminals and apply 53 kPa to manifold side nipple, im going to try that next, also, not to...
Top Bottom
Back
Forums
Menu