Search results

  1. B

    91 5.0 GT FUEL PROBLEMS, PLEASE HELP!!!

    Just installed a new ECU and she RUNS! Never been so excited to turn the key on and hear the fuel pump buzz! I greatly appreciate all the help!! Thanks again
  2. B

    91 5.0 GT FUEL PROBLEMS, PLEASE HELP!!!

    Once again, thank you very much! With your help, we are going to get this baby running. OK, I repaired the computer ground to ohm at .3 just as if the tips of the ohm meter are touching and still no fuel pump turn on when key is on. I had 5.2 volts from probe 22 to battery. I found the...
  3. B

    91 5.0 GT FUEL PROBLEMS, PLEASE HELP!!!

    Thanks jrichker, When checking the computer you said, "With the ignition switch in the run position, connect a test lamp to the battery and back probe pin 22, the light blue/orange wire with it." Do I connect the test lamp to the postive or negative on the battery? I ohmed the...
  4. B

    Fuel Pump has no Power.

    I looked the ground over by the battery (just to make sure I was looking at the black cylinder, it is the one that pulls apart in the middle by squeezing the clip,right) and it looks fine. I ohmed from ground to the other side of the cylinder and it read 2.2. Is that too high? Could the...
  5. B

    91 5.0 GT FUEL PROBLEMS, PLEASE HELP!!!

    Well it just quit while I was going down the road. I have messed with it all day and here is where I am at. I replaced the Fuel pump relay and still only have 2.6 volt going out of the green wire (from the fuel pump relay) and I have the same 2.6 volts going in and out of the inertia...
Top Bottom
Back
Forums
Menu