Search results

  1. will1992

    5.0 running rich pulled codes 21, 31, 44, 22, 66

    i wasnt sure if i put the sol vacuum lines on the right valves, so i found a diagram like the one above and so i looked on my car and saw that the wires werent blk/grn and red/wht and i did a search to find out what color they were so i could be 100% positive that they were hooked up right. i...
  2. will1992

    5.0 running rich pulled codes 21, 31, 44, 22, 66

    i was looking at my tab/tad solenoid vacuum lines today and i tried switching them around,and i started the car and it didnt smell like gas. i htink i had them crossed. the tab red-wht/ylw line was going to the air diverter valve and the tad red-wht/grn vac to the air bypass valve, but i'll...
  3. will1992

    roller rocker adjustment ?

    this should help http://cranecams.com/pdf/425e.pdf and here Ford Racing 1.7 Performance Roller Rockers - Stud Mount (289/302/5.0L/351W) - Installation Instructions at AmericanMuscle.com - Free Shipping!
  4. will1992

    5.0 running rich pulled codes 21, 31, 44, 22, 66

    Will a low battery cause codes to come up. because i think i may have run the codes with a low battery after letting the car sit for a few days. so, i hooked up a jumper box to the battery and what do you know, no damn cel aaaaaaahhhhh i hate my car right now, but it still smells like fumes for...
  5. will1992

    5.0 running rich pulled codes 21, 31, 44, 22, 66

    ok thanks. but why is my car running rich. i only did the test one pin at a time do i need to do both pins c, d and ground to test the circuit correctly cause it seems like i did it wrong
  6. will1992

    5.0 running rich pulled codes 21, 31, 44, 22, 66

    i checked the maf sensor and i couldnt get a ohm reading between ground at either pins d or c does thet mean the new sensor is trash and where can i get a good one
  7. will1992

    294 rear wheel hp???

    wow im kinda jealous those numbers they sound healthy... too healthy. if you think your going to blow it up why not get it tuned so it doesnt self destruct
  8. will1992

    5.0 running rich pulled codes 21, 31, 44, 22, 66

    here are my results, i couldnt test the bap bcause i dont have a frequency meter code 31- evp- pin 27, 46 is at .55v im going to try this test tomorrow again on the sensor code 21- ect- pin 7, 46 is at 2.62 v @86 degrees sensor has 27.27 ohms resistance (engine cold) code 66-...
  9. will1992

    5.0 running rich pulled codes 21, 31, 44, 22, 66

    man thats alot of things to do but it has to be done ill check as much stuff tomorrows as possible, thanks guys
  10. will1992

    My set up followed by dumb questions

    i dont think b303 cam is smog legal. i read that the gtp heads burn cleaner and more efficient due to more efficient port shape and the spark plug moved more toward the center of the combustion chamber so it might pass the sniffer, and with all the visual stuff "hooked up" but i know nothing...
  11. will1992

    5.0 running rich pulled codes 21, 31, 44, 22, 66

    yeah after i replaced the maf, ect, and bap/map i left the negative battery cable unplugged for a day and started her up and got no codes, now after running a few times the Cel came on and i got the codes. how do i test those sensors?
  12. will1992

    5.0 running rich pulled codes 21, 31, 44, 22, 66

    my 92 mustang has been running really rich and today and it finally happened the cel came on so i pulled the codes. here is what i got koer: code 21- ect out of range code 31- pfe, evp or evr circuit below minimum voltage code 44- thermactor air system inoperative-right side koeo...
  13. will1992

    Performed cylinder balance test....results.

    i checked my injectors with a auto stethoscope today and heard ticking on them all, meaning they work. i also checked my spark plugs and they all were consistent, none of them were very wet. i then checked my fuel pressure with a guage hooked to the shrader valve, and it read at 35psi running...
  14. will1992

    Performed cylinder balance test....results.

    when my car is idling it shakes for second, stops shaking for about 3 seconds then shakes for a second then stops over and over, tomorrow ill check my injectors. ive replaced all vacuum lines when i put all my vacuum stuff in the fenders. i dont have any vacuum leaks or anything, it just started...
  15. will1992

    Performed cylinder balance test....results.

    pulled koer and koeo codes and got a 11. i put in a new egr,map,and maf in; bad ground
  16. will1992

    Performed cylinder balance test....results.

    thanks so my car might be acting up because of someething other than the injetctor becau se it passed the cylinder balance test
  17. will1992

    Performed cylinder balance test....results.

    thanks i never thought of this before, how do i reach the injectors under the intake?
  18. will1992

    Performed cylinder balance test....results.

    i just noticed my 92 mustang gt motor shakes i think it has another bad injector i replaced one and it ran good for a while, but after i had it rebuilt it shakes slightly from idle to 1500 rpm. i dont know whats wrong with it i did a cylinder balance test and got a 9 that means its running like...
  19. will1992

    Performed cylinder balance test....results.

    why not i have replaced a bad stock injector with a disc style and it runs great
  20. will1992

    longtube headers. cant get them out!

    or you could try to loosen the motor mount nut on the side you are trying to work on and lift it that way instead of loosening the tranny mount or driver side motor mount. here is a link to a trans cm looks like its on the bottom (black...
Top Bottom
Back
Forums
Menu