Search results

  1. Jim Wilson

    Fox Vibration After Gear Change

    On the coat side. By center i mean the inside of the ring gear. The drive side was almost centered in the ring gear
  2. Jim Wilson

    Fox Vibration After Gear Change

    I am gonna pull the driveshaft off this weekend and recheck the pinion. I will check the pinion angle. The coast side pattern was toward the center of the ring gear but not all the way to the center. The drive side was almost center. Where is the weight on the rear end? I will check that and the...
  3. Jim Wilson

    Fox Vibration After Gear Change

    I just went from 3.08 to 3.73. Around 60mph I am getting a vibration when I let off the gas or push in the clutch and coast. I measured the backlash at .11 and had about 25 inch pounds on the pinion preload. I replaced everything in the rear bearings, seals, and races. Any ideas? Im going to try...
  4. Jim Wilson

    Lights

    Thanks a lot guys
  5. Jim Wilson

    Lights

    When I use my fog lights at the same time as my headlights after a 1/2 hour or so all the lights will cut off and on. My question is. Is there a regulator or something I could be overloading? If I dont use the fog lights I never have any problems. Thanks
  6. Jim Wilson

    E303 benefits

    Thanks that is what I thought with only a cam
  7. Jim Wilson

    E303 benefits

    I have a 90GT bbk equal headers off road hpipe w/ flowmasters, and bbk cold air. How much would I benefit from a E303 ford racing cam with everything else stock?
Top Bottom
Back
Forums
Menu