Search results

  1. fivemustangs

    Pypes O/R X pipe? Or...........

    What is a good Off-road X or H pipe that is cheap? I have looked at mac, pypes, Dr. gas, UPR, SLP, and Magnaflow. The best deal I have found was Pypes O/R X pipe stainless steel for $180 shipped on Ebay. But all the fourms I have read say they fit like S**T, but its hard to pass up a SS pipe for...
  2. fivemustangs

    New dyno numbers!

    Yes in all reality I prob. should not be messing with the tune right now. He did load a 93 octane tune that i still need to load when I get better gas and I will be replacing my H pipe soon. How much power can I see with an Off-road H pipe? I do have autometer gauges wideband, fuel pressure and...
  3. fivemustangs

    New dyno numbers!

    Does anyone know more about this timing situation or can someone hook me up with a link that explanes more about adding subtracting or everything about timing 99-04 2v engines? I see on KB website they did all there runs at 11:1 A/F and 23* timing, so could I be missing out on 8* of timing on a...
  4. fivemustangs

    gauge cluster wiring diagram?

    Nice that is Just what I was looking for. I pulled the gauge cluster apart today because I knew it was either a loose ground or power wire. What happened was the black connector, that the right harness plugs into pulled out of the circuit board. So I just pushed it back and re-sodired it back...
  5. fivemustangs

    New dyno numbers!

    Ya i thought 360 was a little low myself. I am still running the stock H pipe for now but hope to be replacing it soon. is 15 degrees of timing low? because it was on a dynojet but he said that was all he could get because I was rocking gas from last year! but he set me up with a 93 octane tune...
  6. fivemustangs

    New dyno numbers!

    So I got back from performance dyno in NH yesterday and the numbers were 362hp and 372tq air/fuel was around 11.5 at WOT and he was running 15 degrees of timing due to old gas. He wrote me 2 tunes, one for 91 octane and one for 93 octane he said I could add more timing with my SCT Livewire when...
  7. fivemustangs

    injectors not firing

    It is more then likely the power or the ground wire that goes to the cluster. I have removed the cluster a good handfull of times and think the pins have loosed up maybe? When I wiggle the right side harness the power will come on to the gauges, the car will start and run like a charm! I had the...
  8. fivemustangs

    gauge cluster wiring diagram?

    Does anyone know were I can find a wiring diagram for the gauge cluster on my 02' GT? I think the main ground or power wire has a loose connection because car will not start and run without me wiggling the right side harness. When i turn the key to the on position there is no power going to the...
  9. fivemustangs

    injectors not firing

    Ok I have been outside working on this problem for the last 6 hours and have narrowed it down to the gauge cluster. I removed it during the process of removing my nitrous wiring and wiring my new gauges, If I wiggle the right side harness the gauges will get power and the car will start and idle...
  10. fivemustangs

    injectors not firing

    Anything?
  11. fivemustangs

    injectors not firing

    I used a noid light to see that my injectors are not firing, I did some intercooler piping and removed my nitrous kit and wiring and now the car will not start. Also the gauge cluster does not get power exept a few of the bottom lights. car turns over and has spark and fuel pressure but no...
  12. fivemustangs

    5.0 replacement

    Ya it is a nice cam and was streetable in a mild build, also has a nice idle noise. Im not sure what your plan is for your stang, but just getting a low mile short block then buy some used aluminum heads and do a H/C/I would be a nice upgrade and still in the budget compaired to having someone...
  13. fivemustangs

    No Spark

    Did you test your Stator? inside the distributor maybe it got fried. cheap easy rebuild.
  14. fivemustangs

    Suspension Setup - Street/Road Race?

    Maximum Motorsports is still a highly recommended company. subframe connectors, springs, control arms.....ect.
  15. fivemustangs

    5.0 replacement

    I dont think you will gain a lot of power from a E303 cam just idle noise, but I may be wrong. I have used TFS stage 1 cams with my mild set ups. good sounding and mild power increase, also works with stock springs and lifters.
  16. fivemustangs

    DIY air to air intercooler on Kenne Bell for 92 LX

    MAINE! I thought I was the only one on :SNSign: nice work! :nice:
  17. fivemustangs

    Maine Cruise 50+ mustangs!!!

    Ya I have heard good things about performance dyno and I have had nothing but bad luck with the tuner in Maine He knows nothing about fuel injections.....So now I gotta drive 4 hours to get it tuned. But the cruise is going to be a fun event, We have a group of 3-4 mustangs cruisng up from South...
  18. fivemustangs

    Maine Cruise 50+ mustangs!!!

    Also this is our second annual event, they know we are coming and cheered us on last year, its not a total "crash" we are a friendly group of mustang lovers and have respect for the vetts as they do for us. It is just a little friendly compitition.
  19. fivemustangs

    Maine Cruise 50+ mustangs!!!

    Were not messing with them, we just all happen to be showing up to view there car display with a bunch of mustangs.
  20. fivemustangs

    really bad smell

    Is your PCV system hooked up? may be getting oders from oil residue crankcase venting.
Top Bottom
Back
Forums
Menu