Search results

  1. M

    Drivers Door Rattle

    I thought I had seen something like this before, but has anyone experienced the drivers door rattle when the window is all the way up. And if so, did you fix it and how. Thanks.
  2. M

    Help w/ High Speed Vibration

    I would try rotating your driveshaft, and simply balancing your tires. This is cheapest route first. Unbalanced tires can do this. I have had tires before that would vibrate between 50 and 60 mph only. Then go from there. I bet you would be real pissed you change your driveshaft and find...
  3. M

    Rear end noise???

    When does it do it? I had a grinding problem in my 2001 after taking long highway trips and then turning. The bearing in the end of my axles were trashed. Luckily, the warranty covered it. I was told from Ford that some Mustangs come from the factory w/ not enough fluid in the rearends...
  4. M

    Got my car Dynoed today... Graphs, Kinda scary A/F

    If you look at the dyno graph, how it is really wavey, this means that the engine is starving for something, I would at least look into the fuel pressure and see what it is doing while under spray, the A/F ratio given isn't too lean. In fact it looks fine. But what kind of A/F ratio was he...
  5. M

    New Wheels, 315's, and Steeda Spring Pictures

    If you have C/C plates, have them run little more positive caster. This gives you a lot more stability at high speeds. When I was doing some test w/ mine, I had the caster set to 4.75deg and at 120 mph it was like a rail. Also in corners, w/ more positive caseter it will actually push the...
  6. M

    Dog bone

    I think of it as a little help in traction to. I need it.
  7. M

    Dog bone

    It may help w/ some vibration, but it is mainly for wheel hop. By mounting it in rubber and the extra weight, it makes the harmonic resonance out of the range that rearend normally sees. I would never take mine off, but that is me.
  8. M

    Best bang for the buck S/C

    Yes, this was awhile back, first time at the track, and I think it was even my first run, the two following were not as good ( I think one was faster but less ET). I have yet to take it to the track yet because where I live they closed down about 3 months ago. I missed the track w/ the install...
  9. M

    Best bang for the buck S/C

    Even though the KB is a lot of money, I can't complain. The instant boost is nice for streetability and daily driving. I makes getting to highway speeds a breeze. And you can enjoy the boost w/out getting into higher rpms. Which I don't like personally, but many enjoy.
  10. M

    Eibach Sportline Owners: Come On In....

    In my opinion, stock cars need C/C plates. Here at Hunter Engineering we specialize in undercar maintenence machines(aligners, balancers, tire changers, lifte, etc.). My mustang along w/ every one that I have worked w/ the camber in almost never the same. My Mustang the camber was a degree...
  11. M

    Downshifting

    Along w/ the clutch, I was always told (not sure if it true) that any back pressure on any transmission (worse for automatic) is bad. Now this may be just looking at the gear issue as talked about above, and if this is a case like stated nothing last forever. I down shift once in awhile becaue...
  12. M

    Inside Dome Light Question

    WD-40 the latch. I have a 98 SHO and the light stayed on. I pulled the relay for about 1/2 a year and then read somewhere how to fix it. It fixed it and the light never stays on anymore. Also learned to use my parking bread at least once a week to keep the rear brakes firm :nice:
  13. M

    Which Mac pipe is better?

    :rlaugh: :lol: :nonono:
  14. M

    MAGNAFLOWS GOING IN, NEW TIE RODS....

    You should get the Steed X2 ball joints since you are going to need an alignment anyway. I replace mine in less that 2 hours. If you have acces to a press (or anything to get the old ones out and the new ones in you can easily do it yourself) and then you will have a little rake to the car...
  15. M

    Cracked Intake?!?!

    If you are interested, I have the intake off my 01 GT (not sure if it will work or not), I put a Kenne Bell supercharger on and it comes w/ its own intake. It has less that 40K on it. I have a lot of stock stuff that was not put back on w/ the KB install. Let me know, I am sure we can do a...
  16. M

    Most Mileage Before Problems??

    Rearend bearing went out at about 35000, under warranty. I have 45000 and have had no problems thus far. Replaced stock tires at 20000 and then replace the new ones at 43000.
  17. M

    Stock 1/4 Times

    Try low 14's w/ street and high 13's w/ slicks. Mine if posted on the left w/ street and 1st time at the track :D
  18. M

    Ram-Air

    :rlaugh: I am not trying to impress you, don't care to. But I have taken intake temperatures from the stock air box and a fenderwall CAI. The temperatures are the same. Our stock air box pulls air from the same place as the CAI pull from. I have even pulled the snorkel and got the same...
  19. M

    better sound from shorties?

    Weird, I was just thinking I should do this today. Maybe it is a sign. :D
  20. M

    Sugar/coke in gas tank will damage engine. Fact or Myth?

    Well forget that then, I tried reading all of there "already asked question", but there is hundreds of them. I guess I wasted my time. :(
Top Bottom
Back
Forums
Menu