Search results

  1. SMOKEDYA

    99 Mustang Gt Instrument cluster and pcm

    Having sorta this same issue. My 02 gt cluster reads all dashes cranks wont start no fans come on no fuel pump prime, theft light flashes rapidly then goes out briefly followed by what i have read is a code 16. Neighbor plugged in his scanner to my OBD port and ECM is not communicating with OBD...
  2. SMOKEDYA

    1999 Mustang Gt 5 Speed Pcm Communication Problems

    Going to bring this back from the dead. 2002 GT cranks wont start, dash reads all dashes,no fuel pump no fans come on theft light flashes rapidly for a few minutes then gives a 16 code. Neighbor tried his scanner but the OBD II port is not communicating with the ECM it said. Power at the inertia...
  3. SMOKEDYA

    Electrical Low voltage

    Well yet another update.... Checked the fuses and found one fuse blown in fuse box,not sure what fuse,assume it was the alternator fuse? But it now holds charge at the alt of 14.2 and battery 14.xx no battery light and the gauge reads fine like always..... fingers crossed it was just a fuse...
  4. SMOKEDYA

    Electrical Low voltage

    Small update. I installed a new engine harness since mine was shot. Jumped the car with my wifes truck. Battery gauge was in the middle but the battery light was still on? Unhook the jumper cables from her truck and the car dies! Hook them back up, and same thing. Battery gauge reads normal but...
  5. SMOKEDYA

    FE Build instrument cluster stopped working

    If i switch out my cluster in my 98 then i need to do the key and ECM due to the PATS.
  6. SMOKEDYA

    Electrical 87-93 Engine Harness differences

    Would the 89 be best when doing a mass air swap in my 86 then? I have a A9L from a 88
  7. SMOKEDYA

    FE Build instrument cluster stopped working

    Now i just need to figure out my charging issue with my 98 GT :crazy::bs:
  8. SMOKEDYA

    FE Build instrument cluster stopped working

    Well hopefully i fixed it.. The circuit the fuse was blown on was #15 and was labeled cluster,low engine coolant switch,warning chime, low oil warning relay,air bag diag moduale Noticed the low coolant sensor in the over flow was removed when the previous owner installed a new one. Seen bare...
  9. SMOKEDYA

    FE Build instrument cluster stopped working

    The fuse blew in the fuse box under the dash, replaced it and blew again.... must be a short somewhere...
  10. SMOKEDYA

    Electrical Low voltage

    nobody?????
  11. SMOKEDYA

    FE Build instrument cluster stopped working

    Search here didnt turn up much. Basically as the title says. In my 95 gt the cluster stopped working. Everything did except the bright light indicator and the dash lights.... No gauges work at all.....
  12. SMOKEDYA

    Electrical Low voltage

    Out of the blue my 98 GT battery light came on. I checked the voltage at the alternator and was getting like 12.xx, checked the voltage at the battery and was within +/- .x Checked the alternator and battery off my 97 the same as i did on my 98 and got 13.5 at the alternator and 13.xx at the...
  13. SMOKEDYA

    93 Cobra Boosters - Don't Get Taken for a Ride

    here is a picture of the amount you will need to in large the hole for the sn booster. I wanna say its about the same amount of hole diameter down to make it fit. I have also seen guy's just cut this stud off and only run 3 studs...:shrug:
  14. SMOKEDYA

    Cadillac ATS Brembo calipers

    ok good to know thanks. i was not sure on the difference...
  15. SMOKEDYA

    Cadillac ATS Brembo calipers

    whats the difference in the ATS caliper and the 03 cobra caliper, besides brembo?
  16. SMOKEDYA

    SOLD Brand new Brembo ATS calipers and new S&S mount kit for sale for SN-95 spindles

    I know these sold,but were they 4 or 6 piston calipers?
  17. SMOKEDYA

    Engine Hessitation then full power

    Oh yeah i might add the fuel pump went out months ago and replaced that as well as a new fuel filter...
  18. SMOKEDYA

    Engine Hessitation then full power

    The car is a 98GT and has CAI, BBK throttle body,catless H pipe,and is an auto,stock heads and PI intake (dorman :() I have a weird issue after installing a PI intake and the other mods above (never noticed this issue that i remember with it being stock). I can hold a steady RPM and throttle...