Search results

  1. Mustangless

    lambse, kams... rich?

    Here is my tune http://eectuning.org/node.php?rid=108 Here is my log http://eectuning.org/node.php?rid=109 My fuel table - open loop only goes down to 11.213. But in the log, my lambse is around 10-10.7? :shrug: It was not running lean according to the wideband.
  2. Mustangless

    Air bag code 84

    Did you reset the codes after installing it?
  3. Mustangless

    Air bag code 84

    If you reset the codes (connector) it will probably come back on. Intermittent or Repaired RH Radiator Primary Crash Sensor Not Mounted to Vehicle is what the code says. I would look and make sure the crash sensor has a good connection, if you reset the codes and it comes back on. My brother...
  4. Mustangless

    Black wing Black wheels....found a better pic

    I noticed 2-3 "new edge" mustangs the past couple of days with the black spoiler. I am really wanting one now.
  5. Mustangless

    lambse, kams... rich?

    Just came back from the track. Made a terrible pass, and the car down shifted again. It felt like it went from 3-2 when I was around 4500 rpms, so of course it just shot the rpms up. Came back to look at my log, and it did not even save. :nonono: Let it sit for a while and under...
  6. Mustangless

    lambse, kams... rich?

    I don't know what my startup problem is. I changed nothing that should effect it and it has only done it once more. I know I can have my kams about 5% lean/rich, but when I come to a stop they go up to 1.07. When accelerating they drop down as low as .94. I still have not changed my...
  7. Mustangless

    What seats are these?

    I think my brother's cobra has those.
  8. Mustangless

    lambse, kams... rich?

    thought I had my "warm start-up" problem fixed, but I guess it was just cooling down too much. My original post here I know I should tweak FN348A, but I don't know how. I don't have BE on my desktop, but if I remember the multiplier in some spots was .80. Do I just take 45% off of all...
  9. Mustangless

    What's Your Automatic Transmission Temperature???

    How bad is it if you run your transmission below 150? My log when I had down-shifting problems (here) my TOT was 124*
  10. Mustangless

    What's Your Automatic Transmission Temperature???

    what is a dangerous temp? After running a little harder on a 70* it went to 160*. Then with just some cursing it got up to 170, but no higher. I am sure if I would have gone WOT, it would have gone up. I have a transmission line either really close, or laying on some exhaust, so that is...
  11. Mustangless

    Quietest muffler you can have

    Sound Off in Quietest to Loudest (Decibels): 1.Borla XS, 80db at idle, 90db at 2,000 rpm, 110db at WOT. 2.Hooker Maxflow, 80db at idle, 90db at 2,000 rpm, 120db at WOT. 3.Magnaflow, 82db at idle, 91 at 2,000 rpm, 114db at WOT. 4.Flowmaster, 82db at idle, 93 at 2,000 rpm, 115db at WOT...
  12. Mustangless

    Got back from yet another long trip and must say...

    :hail2: what gears do you have?
  13. Mustangless

    Does header wrap work??

    it works by helping keep the heat down. I have my about 2' behind my turbo wrapped, only because it is so close to my intake. When I took it off after about 8 months everything looked fine. I would never wrap my headers though. I have seen pictures of what the others are describing.
  14. Mustangless

    lambse, kams... rich?

    I think I see what I should have known years ago. I don't want to just focus on getting my afr at 11.6-11.8ish by messing with the maf curve. I need it to match my lambse as close as possible. I know it commands like 11.2 or something, but I can always change that to 11.6. On that short...
  15. Mustangless

    lambse, kams... rich?

    You are talking about the maf transfer right? Couldn't I just use caledit and select 17-30 and richen it 10%?
  16. Mustangless

    lambse, kams... rich?

    I did a short WOT pull and when my mafv hit 3.5ish the afr goes from 10.8-11.8 to 12.4-12.8 :nonono: I don't want to, but it looks like I will have to do some work with the curve. http://eectuning.org/node.php?rid=103 I'm not too far away from there. Probably alittle over an hour away.
  17. Mustangless

    lambse, kams... rich?

    I logged with calcon today and was in CL most of the time. So I think something is wrong with BE logging. My kams are all over the place and I see no pattern to them. As low as .94 and up to 1.08. But they are mostly staying 1 give or take .02. my slopes are 43.5991 high 48.4984...
  18. Mustangless

    lambse, kams... rich?

    I will have to work with the wideband this weekend. I was just looking over my log and it seems it goes out of CL when it starts slowing down. Then when I start to accelerate it goes back. I could have it backwards. It might go to CL when slowing and OL when accelerating LOG Almost like the...
  19. Mustangless

    lambse, kams... rich?

    after researching, I think I have lean decel not lean tip-in. The only thing I dislike about it is the car starts jerking, kinda like driving over bumps. This could be another problem though. When I calculate my offset EA tells me to move my 14.00 from 0.7500 to 0.8932. Does that mean it...
  20. Mustangless

    lambse, kams... rich?

    I have been messing with this for a while. I am having better luck, but I guess it is going to take time. My newest logs show my avg ltft 1.05 and EA recommends me changing high slope from 43.6 to 41.6535 and my low stays at 49. It also recommended mine adjustments for my offset, so I will do...
Top Bottom
Back
Forums
Menu