Search results

  1. BPA

    GT-40's are back from the shop with flow numbers.

    Too bad you dont have any pics of the porting job you did darn.. Anyways good #'s :nice:
  2. BPA

    msd cap and rotor.

    im with them.. if your worried you can always pencil in what wire # it is on the top and on the cap
  3. BPA

    My brakes are mooshy

    invest in a little bottle pump bleeder.. like this one.. http://www.thetoolwarehouse.net/shop/CAL-855.html i think u can pick one u for around 100 buck or so.you may need to buy the atachment for like 20 bucks to fit it on your car .. U fill the bottle with brake fluid and attach it to the...
  4. BPA

    low end miss with power loss

    im asking what his mods are to figure out why he said a9l.. ..lol
  5. BPA

    Putting the new motor in, some questions

    im sure you can run it at 10 with the spout out and be worry free .. dont get on the gas much till you tune it .. baby it around
  6. BPA

    low end miss with power loss

    ummm.. can you try to tell us a little about what mods you have done and how long this has been happening? Clean your MAF, Ohm out your plug wires and check the plugs too .. See if that helps.
  7. BPA

    Tubular Front end w/ coil-overs, streetable?

    My buddy has the full griggs suspension on his 95. He hasnt had any issues with it driving on the street in the 3 years he has had it on.
  8. BPA

    Pretty significant oil leak, where could it be coming from?

    Well maybe you have a bad muffler bearing:shrug: , no but seriously.. Iwould try to find the highest point there is oil. Lower intake manifold or valve cover are very possible.. If you suspect eather and still are unsure you can always clean them down with brake clean( engine cold!) or...
  9. BPA

    Need help with new motor please!!

    make sure you dont have your dizzy 180 off but timing around 14 should be ok with the spout out..
  10. BPA

    engine gurus needed

    what combo are you going with....
  11. BPA

    sterio wiring diagram please

    Thanks bro the link to the 12volts.com worked for what im doing. i was just tryign to figure out what color wires were the + on both rear speakers were.. Thanks again... Brian
  12. BPA

    sterio wiring diagram please

    Can some one please post a wiring diagram for the 94-95 sterios with tape and cd and without mach.. thanks guys i want to make sure im picking the right positive wires to the speakers and not the negative rear deck speakers
  13. BPA

    charging problem?

    Check our battery ground cable as well.
  14. BPA

    Cheapest place to get a short block

    Well im assuming you just want a stock reman unit. I think having your existing short block rebuilt would be even cheaper look at the prices for a rebuild kit and find out how much local shops will charge to install the parts if u dont feel comfortable doing so. just an option, sorry i couldnt...
  15. BPA

    Very unsettling engine behavior - Please help.

    you can check for dtc's without a code reader. do a search and you will find the info
  16. BPA

    Very unsettling engine behavior - Please help.

    No dtc's set?
  17. BPA

    wOULD AIR IN THE BRAKE SYSTEM CAUSE THIS?

    ok im a little confused maybe im not reading this right.. did you replace your front and rear rotors and pads after you replaced the caliper?thanks for the clarification in advance. Brian
  18. BPA

    ford racing supercharger ??

    agreed... do a seach on powerdyne's you will find useful info.. they have limiting boost levels without destroying the heat unit rpm wise. Id go with a vortech or Kb. As long as ur engine is in good tune you will be fine.boost is fun you will like it. good luck
  19. BPA

    What can be draining a battery?

    I like my fluke 88 very good meter but pricey if ur not using it much..
  20. BPA

    3:55 or 3:27?

    getting a 6 speed tranny might help ya...:rolleyes:
Top Bottom
Back
Forums
Menu