Search results

  1. 8

    headers worth it on stock setup?

    I have JBA shorties and they made a difference for my Stang. Not huge but a worthwhile difference. More than my underdrive pulies did for sure. I also have Bassani catted X pipes and stock mufflers. Much better performance than those sad looking stock tubes for sure!!
  2. 8

    Holley Fuel Pressure Regulator!

    I would NOT recommend to my worst enemy the Mallory that I bought a few years ago. It leaked like a sieve, called tech and they said just put on new O rings and sent me a set for $20. Did nothing so they said ship the regulator with new O rings and two to four weeks they would ship me a new...
  3. 8

    intake clear my hood ?

    I know it wont fit under my Kenny Brown strut brace with a spacer but will without one. Hood clearance is no problem with my Cervini Cobra R hood!!
  4. 8

    Aluminum Drive Shaft question

    Try eBay I got mine for $150 delivered. It is used but looks shinny and new. If it is used it could not have been driven too long!! I think it will require me to reuse the mounts front and back. It does have new or near new U joints both front and back!
  5. 8

    Would gears require changes to Speedo?

    I got mine from Ford (Mistake $13.20) 3.73 Gear Ratio / Red 21 Speedo Gear. It is the right gear according to Ford and BBK charts! For 3.73 gears you need 21 teeth (RED) forf 83 to 89 model years, a 23 teeth for years 90 to 98. Automatics from 83 to 98 need a 21 teeth (purple). Newer models...
  6. 8

    Injectors??....will i need bigger ones?

    You dont need them but when you decide you need replacements you could go one size bigger! If you have the stock cam I would sure like to see some 1.7 Cobra Rolling Rockers. Of course I am sure you know that new heads would make those bigger injectors really purr.
  7. 8

    Best water pump ?

    I put in an Edelbrock pump about 10 years ago and it works fine and keeps me stang real cool! :nice:
  8. 8

    twEECer anyone?

    To the best of my knowledge, this is the only product that can be used to reprogram an SD car.
  9. 8

    What gear oil??

    Isn't Synthetic (Redline) 75W90 gear oil what should be used??
  10. 8

    Cobra Intake Install on my 87 5.0

    Appreciate all the help guys. Going to put on all those new parts even though that will put the project back a few weeks so I can fund it!! Does anyone know where I can find a list of all the bolts and washers, hoses and gaskets that use to come in the kits?? I want to buy all new parts...
  11. 8

    93 cobra brake booster

    No it is bigger internally and externally!
  12. 8

    What all should be done during a tune-up

    Magnaflowgt, My experience with dealerships and tune ups is that while they do a complete job they are ultra expensive and the warrantee on a tune-up is worthless, litterally!!
  13. 8

    Cobra Intake Install on my 87 5.0

    Thanks again for all your help and suggestions. They give me a little more confidence in doing this project! :nice:
  14. 8

    Cobra Intake Install on my 87 5.0

    Just dont feel good about injectors with over 120,000 miles on them and why not upgrade to 24#? Mass air?? I have speed density. Going to push it as far as I can and if it fails I will either get a custon chip or convert! Maybe someday I will get a power adder and use the bigger injectors...
  15. 8

    MSD 6A Ignition Controler

    I have never owned an MSD but I have heard that some of the units make noise which some think means they will fail earlier than other units that dont have a noise but most think not. From what I hear I cant be sure if all the units makes a noise but some owners dont hear it or some units are...
  16. 8

    Cobra Intake Install on my 87 5.0

    Thanks for all the advise. I think I may opt to put on 24# injectors while I am at it since it was pointed out I should inspect the 0 rings anyways. So I will put on new valve springs, 1.7 Cobra RR, new 180 Thermo and gasket, 65MM TB with new gasket, new vlave cover gaskets, and of course the...
  17. 8

    TB worth the money?

    A bigger TB would do you some good since everything is upraded exept the TB. I would not go larger than a 70MM with an appropriate sized spacer. Just curious but what size TB did you port your upper manifold for??
  18. 8

    Cobra Intake Install on my 87 5.0

    I picked up a Cobra intake upper and lower but what else do I need for my install? Can I use the all the old bolts or do I need Cobra intake bolts and where can I get them and how many do I need? Here is what I know I will need: 1. Upper and lower Cobra intake 2. Felpro 1250 gasket 3...
  19. 8

    Could My T-5 be Going @ 117,000 mi.?

    I have 120K on my T5 and it shifts like new but I am thinking about making my first clutch change soon!
  20. 8

    15mpg...p**sin me off!!! what can i do

    I use to get 16 mpg around town now I get closer to 14 cause I boosted my pressure to my injectors. Better response lously gas mileage. No diff on highway which gets from 20 to 22mpg.
Top Bottom
Back
Forums
Menu