Search results

  1. guevara42

    Sputtering at high speeds.

    Carb and distributor are original. Motorcraft 2bbl carb and the original distributor with electronic point system. Carb was rebuilt less than a year ago and it's been a few years since dist. has been rebuilt. Opened up carb and it's as clean as can be. Thought I may find gunk but it was...
  2. guevara42

    Sputtering at high speeds.

    I will check the fuel pressure and the flow. This only started happening about a week ago. I did put in a new coil about 6 months ago and I think I will try new plugs and wires next. That's the only thing I have not done. Thanks.
  3. guevara42

    Sputtering at high speeds.

    Fuel filter has been replaced recently. Thanks,
  4. guevara42

    Sputtering at high speeds.

    Hey folks, I have a 66 coupe, 289. Car sputters at speeds starting at 65-70 and gets worse if I try to go faster. I have changed everything I can think of. Fuel filters, fuel pump, I put in an electronic ignition about a year ago. New gas tank tank and sending unit. Anything else you guys...
  5. guevara42

    Car stalling in Drive and reverse???

    Thanks guys! It wasn't a vacuum leak and the carb was perfect. It was a bad ignition coil. Replaced it a few days ago and the car is running great. I put the old one back just to test it and after it got hot the car started acting up again. Thanks for the suggestions.
  6. guevara42

    Car stalling in Drive and reverse???

    Hello Fellas, I'm almost out of hair from pulling so much of it out. I have a 66 coupe 289 A/T. Here's my dilema...a couple of days ago driving home from work and driving off the freeway, my car starting sputtering and eventually stalled out. I did start the car back up and drove until the...
  7. guevara42

    Drip Rail Sealer?

    Thanks guys. I went to a body paint shop and they had the 3M #8307 two part sealer that was recommended but it was pricey just because you had to get the gun. If I were a body shop, I'd buy it, but for two drip rails, I'm taking a pass. I found out that 3M does make a one part self...
  8. guevara42

    Drip Rail Sealer?

    Hey guys, I am repairing the drip rails on my 66 coupe. I removed all the existing sealant that was there from the factory due to a little bit of rust that started building. Luckily it didn't go all the way thru the metal and suprisingly there is still great looking metal underneath the old...
  9. guevara42

    Underdash and door light inop!

    Thanks guys. And thank you BarnStang for the schematic and info. I will keep you posted to see what I came up with once I look deep into it. :SNSign:
  10. guevara42

    Underdash and door light inop!

    It's a 66 coupe, 289. I appreciate your help.
  11. guevara42

    Turn signal indicator on solid...

    I know you said you put new bulbs in. But I had the same issue, changed the bulb and presto, it worked. Just thought I'd throw it out there since it happened to me. hope it helps.
  12. guevara42

    Underdash and door light inop!

    I checked all the fuses, good. light bulbs, good. I must have a short somewhere bcuz I remember opening the door yesterday and they were on and drove the car. When I got back, is when I noticed they were out. All my other light work. The instrument bezel, headlights, hi-beams. I will try to...
  13. guevara42

    Underdash and door light inop!

    Posted via Mobile DeviceI forgot to ention that all tje fuses are good.
  14. guevara42

    Underdash and door light inop!

    I just noticed that my underdash and door courtesy lights are not working. All I've done to the car since I noticed them not working is put in an electric fan and a new alternator. Any Ideas? TIA.
  15. guevara42

    Electric fan install!!

    Thanks fella:nice:s. I will do what restomod did since we have the identical fan. I will make sure it goes directly into the fins to where it's tight.
  16. guevara42

    Electric fan install!!

    Hello once again. I just installed an electric fan on my 66 with a 289 . I was wondering if anybody out there has done the same and would be able to help out with the position of the dry bulb sensor. The install instructions has the sensor going through a hole in the shroud of the fan and...
  17. guevara42

    Need A/C unit!

    Found one, thanks!:nice:
  18. guevara42

    What service to ship a fender?

    I used FedEx and they did a great job. The person I shipped to said they received it in great shape.
  19. guevara42

    Brake hoses.

    Can somebody please tell me what this part number is for. Either disc or drum brakes: C5ZZ-2078-B. Thanks in advance.:shrug:
  20. guevara42

    Here's a pic of my ride!!!

    Sweeet ride. One day my car might look that cool. Like the modern look. Good work!:nice:
Top Bottom
Back
Forums
Menu