Search results

  1. cobra_2_76

    Bought another Cobra II

    Is the body in good condition? I think I mentioned before looking under the car at the inside of the rocker panels. Also look at where the unibody fits together. If it's starting to go the seams will have started to expand from rust. Look inside the rear fender wells, another starting place...
  2. cobra_2_76

    Now this is just crazy...

    Look at the bidders, er bidder. I'll bet either the bidder is a moron, note no feedback, or the bidder and seller are the same person.
  3. cobra_2_76

    Bought another Cobra II

    You'll also need a matching harmonic balancer for the front of the crank. The improper imbalance has probably created greater than acceptable clearances between the crank and the main bearings....leading to lower oil pressures and eventual short block failure. You can drop the rack and...
  4. cobra_2_76

    Bought another Cobra II

    If it's a wrong balance, it will be noticeable all the time, not every 5-10 seconds. Sounds like some problem with the fuel or ignition.
  5. cobra_2_76

    Where to find a II?

    Ohio! Your about 1 hour south of me. Email address is [email protected] Dave
  6. cobra_2_76

    Pics?

    Well that seemed to fail, let me try again. Dave
  7. cobra_2_76

    Pics?

    I stumbled across this photo which shows the scoop in better relation to the hood. The hardest part is getting the right combination of parts to get the scoop at the right level....too high and the rubber gasket looks stressed and eventually tears. I'm not sure you can get it too low unless...
  8. cobra_2_76

    Pics?

    Damn, those are nice shots, got to download them. At that time I was using a Weiand Stealth and have since dropped to an Edlbrock Performer to lower the unit. Performer also gives me a tad more torque to match the streetwise cam. I also dumped the air cleaner which I had modified to...
  9. cobra_2_76

    Headers!!!!

    I guess someone should give him the model number for the Hookers - 6120. About $300 per set, but excellent fit and do clear the T-5 without modifications if you use the Mustang II bell and the T-5 with the longer input shaft.
  10. cobra_2_76

    Pics?

    I happened by and have a basic shot of my Cobra with the hood down. Hope this gives you enough of an idea. Not a real close shot. There are some more images on the MustangII.org site. If you want to try is let me know, probably should email me at [email protected] since I don't stop by...
  11. cobra_2_76

    any road racers

    I checked the forum and saw the thread on autocrossing..... Brian, yep the yellow monster had aluminum sway bar mounts, heim joint end links. I don't know if Dan put on my A-arm connection points which were steel with nylon bushings. Then more so than now you had to make your own parts. A...
View older results
Top Bottom
Back
Forums
Menu