Search results

  1. fredfifty

    88 gt rough idle smell of fuel white smoke out of exhaust

    timing?
  2. fredfifty

    Electrical What Connectors Are These? PIC

    Found these near the ignition coil. The small gray one looks like the STI but that plug is already located behind the driver side shock tower. Is it an extra STI? I have no clue what the white and black male plugs are...is one of them the EEC ground??? Any help is appreciated.
  3. fredfifty

    Please Help O2 Sensor Hookup 5.0 Swap

    im getting conflicting info..that o2 sensor looped wire for the t5 looks to be for years 88-90 according to this website http://ponyperformance.com/ (go to technical and scroll all the way down to the o2 sensor harness identification). years 91-93 have a different looped wire (see diagram in...
  4. fredfifty

    Fake Stangs

    yup i see those in my area (sf bay area) and some are even brazen enough to post it for sale on craigslist as a "cobra" until they get called out or the ad gets flagged just as fast as it went up.
  5. fredfifty

    91 5.0 No Injector Pulse

    Also, did a noid test. When i turn key to run the number 8 noid light turns on and is bright. The other injector harnesses dont do that?
  6. fredfifty

    91 5.0 No Injector Pulse

    Sorry to thread jack..i ran a noid test on the driver side injector harness. Number 8 stays on and is brighter than the 5 6 or 7. This is after i swapped to a known working injector harness. Im guessing another computer that works should solve that issue? I did run codes and i recieved a...
  7. fredfifty

    About to get blown....it ain't good...

    hilo got hit hard wow...
  8. fredfifty

    Fuel Injector Wiring. Help Please.

    thanks jrichker also, the noid light kit i have (pittsburg) has several different lights for different cars. the ford one does not fit the stock injector harness receptacle, but the gm one does...would it be ok to use the gm one?
  9. fredfifty

    Fuel Injector Wiring. Help Please.

    i did the tune up to the 10 pin connectors...i still think i have a faulty number 8 injector harness. I have a noid light, but how can i check the number 8 injector harness if the car has to be running, and im assuming the upper intake has to be on? that injector harness is hard to access. let...
  10. fredfifty

    Fuel Fuel Pump - Cant Hear it Prime

    i cant hear my fuel pump prime from inside the car like my other foxes...however, fuel is still getting pushed through. Does that mean i have an electric pump or? FYI car starts and runs (for as long as i let it since it runs rich). Or does that mean my pump is slowly going out?
  11. fredfifty

    Where do I buy an OEM clutch cable?

    go MM, theyre made in merica
  12. fredfifty

    Electrical 1990 connector under passenger kick panel

    looks like the oxygen sensor harness
  13. fredfifty

    OBD 1 code 15.

    https://offerup.com/item/detail/472288618/ he may ship, good seller..ive bought many mustang parts from him (if you end up needing a new ecm) he is in concord, ca
  14. fredfifty

    Electrical 1993 LX 5 speed ECU problem?

    check codes? or possibly timing? im having the same prob
  15. fredfifty

    Electrical wiring harness

    I have a 92 original 5.0..how can I tell I have the 92 engine wiring harness or another years wiring harness? also, if i do have the 92 engine harness, what O2 harness would i need (wire colors) for a manual trans car (i have an A9L ecm)...my 92 was originally an aod car FYI
  16. fredfifty

    Tailpipe alignment problems

    i have the same problem with a pype violator setup I have with 3" tips. passenger side muffler tip sits just past the bumper while driver side is tucked nicely under it. I hate it. ill have to re-adjust it again.
  17. fredfifty

    Engine Motor Went In, Timing Way Off

    also, is the 302 considered to have an acute spark plug angle relative to the flat top piston, which could or may bend the TDC shaft (tdc indicator tool end)
  18. fredfifty

    Engine Motor Went In, Timing Way Off

    So i need to do my timing (finding tdc) but i also need to set my idle, tps voltage, and adjust my fuel pressure regulator. Should i do my timing first? then what after, and so on? From what i searched online, to get tdc on the number 1 cylinder (compression stroke), am i right to pull the #1...
  19. fredfifty

    Fox 3" or 2.5" exhaust setup for stock 302?

    i like it to look discreet and close to stock, not riced out with a 3" tip...it doesnt look good but maybe it will grow on me. id rather do a 2.5' tip but pypes violators doesnt have an attachable 2.5' tip
  20. fredfifty

    Engine Running motor with no coolant

    Just put motor in, wanted to run it for a few seconds to see how it runs. Should be fine right?
Top Bottom
Back
Forums
Menu