Search results

  1. Decipha

    Trouble With The 351

    also keep in mind old junk ass fuel isnt gonna run too great in itself
  2. Decipha

    Fox Bama 4-bank Eliminator Chip - Worth Buying?

    not really You should wire up the fan to the ecu and let the ecu turn it on and off You shouldnt have any idle or throttle response issues Clean out the throttle body, remove the mesh screen under the pcv valve in the back of the manifold and do a base idle reset if you set timing to 14...
  3. Decipha

    Boost Gauge And Wide Band Wiring

    the radio illumination wire
  4. Decipha

    Stalling Issue Please Help

    unplug the spout, throttle position sensor, and idle air control valve with the engine at a warm stabilized idle, adjust the set screw until the engine is just barely idling shut it off, plug all 3 connectors back in and enjoy, give it a few minutes for the idle to relearn
  5. Decipha

    Boost Gauge And Wide Band Wiring

    the headlight switch
  6. Decipha

    Tuning Ecu

    Myself as well as quite a few others that I can think of do so all the time
  7. Decipha

    Digital Tuning Taming The Timing Eating T4m0

    incorrect, 0 demands 0 degrees of timing during a tip in, set it to 60 to disable incorrect, stock value on a fox is 0 and stock on an sn is 2 1= perload is set to load which doesn't use fn035 at all 0= load / fn035 2 = pct_load (inferred) from fn1036 mostly incorrect, prldsw can be set to...
  8. Decipha

    Trouble With The 351

    without code meanings those numbers mean nothing to me, you should post what the codes mean if you suspect the injectors are clogged clean them, remove them, flip them upside down and blow them out with about 200psi of compressed air slap them in should be good as new
  9. Decipha

    60 Lb Hr Injectors?

    btw, just put some 80's in it and be done
  10. Decipha

    60 Lb Hr Injectors?

    42s will ONLY support AT MAX 360rwhp on a v6 heres a calculator for all your needs http://info.efidynotuning.com/pre.htm
  11. Decipha

    'THEFT" Light Flashing. Why?

    thats odd, if pats fails the ecu wont fire the engine odd indeed, but as long as the vehicle still runs i personally wouldnt be concerned with it when pats fails completely and you cant crank the engine, then you have problems nothing a chip/tune cant fix, but with pats disabled in the ecu...
  12. Decipha

    Failed Emissions Again. Guy Said Decarbonize?

    Unplug the spout connector that will lock timing to 10 degrees, low timing=low emissions you might as well thank me now
  13. Decipha

    86 Gt Acceleration Vibrations

    sounds like u either put junk plugs in it or you didnt gap them right I hope u didnt put champions in it
  14. Decipha

    New Guy In Nw Houston, Need A Little Advice.

    Nice, i prefer the 91+ personally keep it BONE STOCK and put an on3 turbo kit on it T76 with 80lbs injectors and PMAS HPX maf 18lbs of boost with a very safe tune will make the car enjoyable and give you the power you want Will be as reliable as can be and youll be very pleased with the results
  15. Decipha

    Mass Air Meter Help

    If it has a tube in it you can just replace it, otherwise, youll have to get the electronics hacked up I would try pmas then prom, one of them may be able to do it
  16. Decipha

    Mass Air Meter Help

    yea what he said ^^ from your question i would assume you have 24lb injectors and a stock replacement bbk meter ideally, if your going to spend the money to get the maf redone get it calibrated for 60lb injectors and get a chip to take care of the tube, you'll thank me later on 24lb injectors...
  17. Decipha

    I Want Meth!

    you do u know you can use straight water too if your only going after the cooler aircharge
  18. Decipha

    I Want Meth!

    I only recommend the AIS kits, been using them for years now and not a single issue. I only recommend progressive controllers on laggy setups, large turbos, etc...
  19. Decipha

    95 3.8 Won't Fire Plz Help

    tool isnt needed, put the crank at 26 degrees (mark should be on balancer) on the intake stroke #1 cyl with the cam stalk making an inverted U with the edge of the U in the center of the window
  20. Decipha

    24 Lb Injectors

    I recommend the ntk afx, its the most accurate low priced wideband money can buy A close second is the aem be sure no matter which wbo2 you get that you get it with a DIGITAL gauge ONLY
View older results
Top Bottom
Back
Forums
Menu