Search results

  1. B

    Who else has had the gears polished

    I think it may be more for true drag racers. Then there should be no break in time when they swap gears at the track.......:shrug:
  2. B

    How to assemble Mach1 Struts

    Yeah, that's what I meant. All the stock GT upper strut mounts parts will work with the mach 1 struts.
  3. B

    Centerforce and SPEC clutches

    try summitracing.com
  4. B

    How to assemble Mach1 Struts

    You'll need all the stock upper mounts to install the mach 1 struts. There is a dust cover, a mounting plate, some rubber bushings, a large top washer and a nut.....I believe. Its been a while since I did mine. Try a search, I think there was a previous post with pics.
  5. B

    Dome light wont turn off

    How in the world did you figure that out????? :lol: :rlaugh:
  6. B

    help, new bad problem

    would a low battery cause stalling though? I would think the alternator should have plenty of power to keep the car running..... Maybe a dead cell in the battery pulling the voltage too low?
  7. B

    My car is not very Nice

    I think you are measuring TPS voltage wrong. I would think if you measured from REF to GND, you should get 5 volts all the time. Measuring from SIG to GND should read around .5V at idle and near 5V at full throttle... Maybe your fuel pump is starting to die???
  8. B

    Dome light wont turn off

    maybe one of the switches in your door jamb went bad?
  9. B

    3v 5.4 question for BillFisher

    :jaw: :jaw: :jaw: :jaw: :jaw: :shock: :shock: :shock: :shock:
  10. B

    3v 5.4 question for BillFisher

    why not just go with a 4V? Wouldn't that be simpler?
  11. B

    K&N FIPK compared to other CAI's

    +1 :bang:
  12. B

    K&N FIPK compared to other CAI's

    as opposed to the non-aluminum MVD???? What are the new ones made of?
  13. B

    Our differentials are lifetime lubed?

    Ford only makes cars to last 50000 miles, so the rear end lube is lifetime! :D :banana:
  14. B

    Upgrading heads on 04 GT

    Post your dyno run and prove him wrong then!
  15. B

    Dashboard Chirping Noise!

    The TSB is for rattling vents. I had the dealer do it. All they did is replaced the center two vents with "updated units". It did help, but it had nothing to do with the "dashboard chirp". Not saying that it couldn't be it, but my vents ratted....not chirped. • CLIMATE CONTROL—RATTLE...
  16. B

    Dashboard Chirping Noise!

    I had the same problem, and thought it came from the dash vent area. It actually turned out to be the wiper cowl squeaking. Its the black plastic piece at the base of the windshield on the outside. It is held in by some metal clips that wear out after time and allow it to move enough to...
  17. B

    NOise

    wiper cowl.... I had a similar problem. Pull it off and wrap some electrical tape around the clips and re-install it. That has worked for me so far.
  18. B

    Dash rattle or suspension problem

    Could it be that your tranny mount is loose? I have heard of that causing a clunk...
  19. B

    Dash rattle or suspension problem

    I've heard that the wiper cowl can squeak at high speeds. Apparently the fix is to remove it and wrap the clips with a little electrical tape to prevent the metal to metal contact...:shrug:
  20. B

    ABC vs. CDC Light Bar

    Thanks for the input. Anyone seen both and know if they are exactly the same???
Top Bottom
Back
Forums
Menu