Search results

  1. O

    question about GT-40 and GT-40p heads

    The engine was rebuilt and I'm hoping that they used notched pistons I'm going have a scope ran in the cylinder and see.
  2. O

    Cometic head gaskets when boosting?

    Hi, I was told that Cometic head gaskets are really good head gaskets when boosting. Anyone run them or have any feed back on them?
  3. O

    question about GT-40 and GT-40p heads

    I was told that the GT-40 heads were a direct replacement. sounds like I need to do some more checking before I tear it down Thanks
  4. O

    question about GT-40 and GT-40p heads

    I have a 1986 5.0 engine and I may have the heads off of it soon I guess the 1986 were not very good heads so I have been checking on getting a different set. I'm told the the GT-40 is a lot better head and I can buy a set right out of the machine shop at a good price. Is it true that if I get...
  5. O

    Made a little walk-around video

    Man these seats are nice? Are they original seats? The wheels are just right--Looks great---
  6. O

    Project Overkill hits the streets

    actually pretty good, I only had it out once and everyone young to old seemed to like it. It gets a lot of looks and finger pointing while driving down the street. I hope to hit a Cruise inn on Saturday and see how it goes. The whine of the blower turns heads. Every time I stop somewhere...
  7. O

    Project Overkill hits the streets

    I finally got the Mustang together enough to do a test drive took like a week to install the supercharger and get the engine smoothed out. I'm so glad I spend the extra 8 hours or so to figure out how to make the heater tubes fit and keep the A/C this thing is such a blast to drive. The...
  8. O

    Thread pattern on SN95 booster, wtf

    See what size metric wrench fit snug over the stud that will tell you the stud size then just look to see if it is fine thread or corse Works with american studs or bolts also "Old school back yard"
  9. O

    exhaust tips with GT bumper pic request

  10. O

    who's running without AC? or without heat?

    I have been looking at some pic's of some really nice fox's but it looks like some of them have had the A/C removed and some even look like they have no heat. anyone running on the street without A/C or heat?
  11. O

    What do you guys think? Two screws and two studs enough to hold an LX wing on?

    I live in West Virginia and we usally just nail them on and then bend the nails over on the inside.
  12. O

    exhaust tips with GT bumper pic request

    That looks good,, better than cutting the GT bumper I went with a cobra bumper I wanted the look of the GT bumper from the sides but also wanted to run big tips with getting to close to the ground. Can post a pic if you want
  13. O

    AC Help

    When I did my V-8 conversion on my Fox I replaced the orifice tube and it was built in the line. I checked everywhere and no one had one for pacifically 134e The only part I found that was for 134a and avable for my 91 Fox was the low side pressure switch. Only thing is to get it to blow...
  14. O

    spark jumping out of the wire??

    I had no choice Mallory is the only company that makes a distributor to fit my 5.0 with a blower-(needed to use a crab cap) and the rotor and cap are new
  15. O

    Project "overkill" has begun -pic's-

    It's 6-71
  16. O

    Project "overkill" has begun -pic's-

    I finished up the fuel system today I ran 1/2 line up to regulator mounted on the Blower
  17. O

    spark jumping out of the wire??

    the cap and rotor are new, Mallory And the wires are new also Summit When it jumps out it's like it is coming right out of the boot. I was just thinking I could trade the parts with another cylinder and see if the problem follows the parts?
  18. O

    spark jumping out of the wire??

    I'm just getting my project running,, So far just a few test fires. When we were cranking it over I noticed that spark was jumping out of the distributor where the the boot is for the the plug wire . I'm running a MSD 46,000 volt coil and a MSD-BTM- box. It jumps about 1" to the supercharger...
  19. O

    Post pics of how your foxbody currently sits

    Almost ready to play
  20. O

    Post pics of how your foxbody currently sits

    Supercharged with air is cool
Top Bottom
Back
Forums
Menu