Search results

  1. 795.0pacecar

    My 351 build with pics

    Maybe there was another problem, like say some kind of gasket leak, and by tearing it back down you fixed whatever the problem was............ No thats unpossible........ lol I work on cars for a living, leaving that off of your engine did not cause your problem.
  2. 795.0pacecar

    brake question.

    Could be a bad master cylinder, a bad caliper, or a bad wheel cylinder in the drums. Take off the wheels and look for leaks. If you dont find any it probably just has a bad master cylinder.
  3. 795.0pacecar

    Rear gas tank and front tilt hood pics..

    I dig the filler neck location. BTW everyone, mid 90s Caprice's and Impalas had flip down license plates covering the filler neck.
  4. 795.0pacecar

    All thats left to show for. :(

    I see your still using the chewbacca defense, I mean the "Im only 16" defense.
  5. 795.0pacecar

    Taller 5th gear in T-5

    I thought astro performance was selling them a few years ago. I dont know if they still do.
  6. 795.0pacecar

    hydraulic clutch conversion for 86 5.0

    Try www.foxmustangrestoration.com, 50resto, or ebay for your fog light. I have thought about putting a hydraulic clutch on my car, but I'm kind of tired of fox mustangs so I cant justify the money or effort to do it lol.
  7. 795.0pacecar

    T-5 transmission fluid whats best

    Overtime synthetic causes the fiber blocker rings to swell and wear out prematurely. Regular mercon dexron ATF is what should be used.
  8. 795.0pacecar

    New Power Distribution Block

    What about the marine power distribution blocks you can get at places like academy sports? I've been thinkin about tryin one out.
  9. 795.0pacecar

    Project boot leg power pipe under way

    I made a cai out of pvc a while back and ended up ditching it and going with a C&L elbow and a stock air box. The pvc started to sag from the heat. Beast I know you've already painted it, but I think it'll really pay off if you spend some time smoothing down the big humps on the ends of the...
  10. 795.0pacecar

    rear main seal leak?

    How many miles are on the engine? With older motors its almost pointless to change the rear main seal, because the new ones will start leaking in a matter of months anyway. The bearings in the engine wear out causing the crank to sag and wear the main seals into ovals.
  11. 795.0pacecar

    T5-Z trans question.

    Reverse is syncroed on all T5s in mustangs 92+ but not in all T5Zs. I've seen some that were and some that weren't.
  12. 795.0pacecar

    Dyno Numbers for the new Setup!!!!

    Thats on the low side of where I figured you'd be. Dont bother going 17-18 degrees timing, you will probably lose power. I've never seen a bolt on 5.0 make power with more than 16 degree timing. You might see 10-15 rwhp with a better intake but you may actually sacrifice bottom end and torque...
  13. 795.0pacecar

    EFI guys, help finding an elbow for my buddy's 347

    http://store.summitracing.com/egnsearch.asp?N=700+4294925239+4294813803+115+4294849255 I have a C&L elbow that I like. I think its 90mm but its kind of pricy.
  14. 795.0pacecar

    5.0 vs. RS Camaro

    How do you figure? Fords bottom of the line v8 mustang vs GM's bottom of the line v8 camaro. Seems fair to me, you obviously got more for your dollar with the mustang back then. Also the TPI 305 would not run with the mustang anyway, it was the 350 tpi with the auto trans that would run with it...
  15. 795.0pacecar

    Man i hate making stupid mistakes

    If you're real good you can press the bearings on before putting the cluster in. I've done it once, and the transmission builder at my shop only does it that way on t5s.
  16. 795.0pacecar

    Boat People Summer's coming

    I don't have a boat but I have an artic cat wetbike. Its like a cross between a jet ski and a motorcycle. Its not warm out today, but it has been warm enough to go out to the lake a few times already. I have the seat off it here. I just rebuilt the carbs and fuel pump today so hopefully this...
  17. 795.0pacecar

    91 LX AOD, delayed hard shifts and wont go into OD

    Im sure its already fried. AODs will fry very quickly with an improperly adjusted tv cable.
  18. 795.0pacecar

    egr help.

    I agree with mustang5l5 however, fordfuelinjection.com sells something that plugs in where the egr valve did to tell the computer the egr valve is pretty much permanently shut. This isn't the best way of fooling the computer but it does work.
  19. 795.0pacecar

    World Class T5 fluid/oil Question

    Always use mercon dexron III or equivalent. I also dont like synthetic in a T5, it causes the carbon syncros to swell and wear quicker.
  20. 795.0pacecar

    SHE RUNS!!!!

    Im gonna have to agree with you guys, it sounds to me like its chugging not lopeing.
Top Bottom
Back
Forums
Menu