Search results

  1. 88mouse

    Best car chase movie?

    I was talking about vanishing point.
  2. 88mouse

    Bad part throttle miss, stumble - No Helpful Codes - Help!

    The balancer has spun.
  3. 88mouse

    Bad part throttle miss, stumble - No Helpful Codes - Help!

    I have been fighting the same problem on another car just got it fix last night. Two of the wires for the maf sensor where shorted out. You need to get the codes with it running. Have it hooked up on a scanner at a local shop.
  4. 88mouse

    QA1 coilover, K-member suspension problems!!!

    Yes the qa1 moves the wheel forward one inch. I have mine for sell now. And this morning ordered a upr one.
  5. 88mouse

    Best car chase movie?

    I've read some where that is was a camaro that hit the bulldozer at the end.
  6. 88mouse

    OEM driveshaft bolt are tight

    There are no alignment marks. Put it in if it vibrates, take it back loose and spin it 180*.
  7. 88mouse

    Best car chase movie?

    :nonono: charger>mustang or camaro
  8. 88mouse

    Funny oil change question

    Yeah. I change a bunch of 3.1 and 3.4 GM intake gaskets at work. There is allways about two quarts in the pan. Ever got water in gas? You can pour the gas off the top of the water.
  9. 88mouse

    Best car chase movie?

    dirty mary and crazy lary is a pretty good one to.
  10. 88mouse

    I NEED HELP!!

    Can you take a pic of the starter relay?
  11. 88mouse

    e7's n 1.7's

    You should be good. The older 351 heads had stud mounted rockers and they didn't have guide plates.
  12. 88mouse

    Funny oil change question

    I would change it before I start it. The coolant will wash down the bearings.
  13. 88mouse

    Dyno time Tuesday at 10AM

    265hp/298tq
  14. 88mouse

    New to the Forum

    welcome to :SNSign:
  15. 88mouse

    351

    I would say 350RWHP. If they are trick flow TW. They are setup to run the fel-pro 1250.
  16. 88mouse

    e7's n 1.7's

    I think he is swaping it over to stud mounted.
  17. 88mouse

    I NEED HELP!!

    did you get all the fuseable links hooked up? The battery good?
  18. 88mouse

    who's got a solid roller setup?

    Just got done put a 347 with a flat tappet solid cam with cnc canfield heads and a holley systemax on it together. sounds good at idle and up to 3000rpm. (fuel pump went out). Going to put a new pump in it tonight and see how it does. Seems like it pull alote hard than the old setup.
  19. 88mouse

    got a question

    I use an air hammer to press them out and the ball joint press kit (for your local auto parts rents them) To press them back in.
  20. 88mouse

    Carpet dye

    I used that duplicolor fabric dye. On my grey carpet, and if wears off pretty fast.
Top Bottom
Back
Forums
Menu