Search results

  1. AdRock

    Beef up the rear...need advice.

    Get a set of 31 spline axles, Moser, Superior. 3 inch studs, and since it's a DD you would most likely be fine with an OEM F150 31 spline diff. Before putting it in have a shop do the mods needed to fit the extra clutches in the diff. Might as well replace all the bearings & seals while...
  2. AdRock

    Fuel Injector Flush/Service

    I put a can of B12 Chemtool in with about 1/2 tank of gas. Then drive the car until the low fuel light comes on. Fill the tank back up. Then within a week or so put a new Motorcraft fuel filter in. I do this about 3 to 4 times a year.
  3. AdRock

    Track Tips

    Since it's your first time out these are the first 3 things I'd suggest. 1. Go around the water box completely. Once your in the lane groove rev up to about 5k and drop the clutch for a 2 count. That's good enough to get the tires clean. 2. Once staged, hold the rpm at 2.5k. When the...
  4. AdRock

    let's talk clutches

    I have a Fidanza aluminum flywheel along with the Fidanza 2.1 clutch. It's been in the car for a while now and I've been very happy with the combo.
  5. AdRock

    Clunking when i shift

    Was the noise there before you changed the pinion seal? If not, I would suspect that the pinion crush washer may have crushed quite a bit more when you tightened the pinion nut. This would completely jack the backlash that the rear gear should see. This could easily cause a loud clunk since...
  6. AdRock

    What quadrant and firewall adjuster to go with?

    I've had a Steeda quadrant & cable adjuster along with a modified OEM cable for a good while now and have been very happy with the setup.
  7. AdRock

    unusual idle/click click - vid inside

    It doesn't sound at all like it has aftermarket cams. With the way the idle hangs then drops I'd bet there's a vacuum leak somewhere. Do you have any aftermarket tune in the car? I s the C&L MAF larger than the stock MAF? If it is and you don't have the ECM tuned for it it could...
  8. AdRock

    Loving gas prices these days

    There are several places here with regular at or under $2 a gallon. San Antonio Gas Prices - Find Cheap Gas Prices in Texas
  9. AdRock

    Broken Motor Mount....

    Yes, it works. I've used this test many times over the years. It's easiest to se in FWD cars though. They seem to have the most flexible motor mounts.
  10. AdRock

    Broken Motor Mount....

    If you want to check the motor mounts... Pull the ebrake tight. Put the car in 1st and let out the clutch a little See if the drivers side of the engine raises up/ or if you feel a thud when you let off the gas. Then put it in reverse and do the same as above se if the passenger side...
  11. AdRock

    WARNING: K&N Oil Filter

    Fram used to be pretty good. I used their filters all the time. Over the past 10 years or so their quality has gone downhill fast. I wouldn't use one now unless I had no choice. Also, he (and me) are talking about the OIL filters not the air filters. You're K&N air filter is fine, just...
  12. AdRock

    BBK intake now available ???

    $1400....... LOL, forget that crap. I'll stick with my stock PI, it works just fine.
  13. AdRock

    WARNING: K&N Oil Filter

    Is there a chance that the old rubber gasket was still on there from the old filter? Either way, stick with Motorcraft.
  14. AdRock

    Broken Motor Mount....

    Spray a little lube into the the rubber exhaust hangers and see if it goes away.
  15. AdRock

    4.6 L Intake Manifold Options

    Take a look at the Hardballer intake from Texas Hot Rods. A buddy of mine has one and it's a very nice piece right out of the box. HPS Hardball'r 96-04 Mustang 2V GT Aluminum Performance Intake
  16. AdRock

    Plenum Combo

    All the plenums are within 1-2 HP of each other, nothing even noticable when you're driving. The only reason to buy the more expensive ones is just because you want it all pretty or just want to say you have that certain brand.
  17. AdRock

    alternative to throwing PI heads in trash?

    With nobody making aftermarket heads, and then a good amount of heads get screwed with a plug blowout.... There's no reason to throw away a perfectly good set of heads. If everybody did that we'd be really paying oput the ass for ported stock heads.
  18. AdRock

    autolite platium plug 1.99

    Why do the Motorcraft coppers only last you 10k miles? They should last much longer than that. I just pulled a set out of my 02 after about 35-40k and they looked fine.
  19. AdRock

    Tire width question

    It also depends on the brand of tire. You can easily fit a Nitto 315/35/17 on a 9" rim since Nittos run kind of narrow but a BFG of the same size should be on at least a 10" rim.
  20. AdRock

    more lay offs at work today

    I'm in San Antonio, who do you work for?
Top Bottom
Back
Forums
Menu