Search results

  1. LX302

    pitted quarter windows

    Do a quick search on painting rear quarter windows. It's been talked about for years. BUt it requires wet sanding them down, primering, wet sand, primering, wet sanding, till all the pits are gone, and it's smooth. Then put on a finish coat of black paint, semi-gloss is good and do a couple...
  2. LX302

    Need AOD help ASAP please!

    If I remember correctly, it's a plug that was installed into the bottom end of the drain tube that goes into the tranny at the factory. When they stuck the dip stick in, on the assembly line, the plug got push into the pan area. So toss it. Anyone confirm this?
  3. LX302

    Looking For Aftermarket Cowl Vent Replacement

    You talking about this one? http://secure.50resto.com/product1.cfm?CustomerID=1968521&ACBSessionID=SD4S5SG1jwwQf4hBkntY&SID=1&Product_ID=217
  4. LX302

    radiator cap leaking?

    Well from your post, your only looking at leaks at the heater core, (inside the car) and at the radiatior cap. I would suggest listening to the above posts and when you take your car for a drive and you smell anti-freeze, shut it down and get under the hood. It could be leaking at any other...
  5. LX302

    TPS Sensors Driving me CRAZY!!!!!!

    5min.s to clear the battery might not be enough. I've always used at least 20 min's. Also, if your using a code scanner, all you have to do is turn the scanner to the hold or off position while it is flashing the codes, and the codes will be cleared out of the EEC. Is your car running bad...
  6. LX302

    Gas guage problem

    Fuel sending unit is located in the fuel tank. When you replaced the pump, you must have a wire/filter screen from the pump hitting or interfering with the float. Remove the fuel pump to check what's interfereing with the sending unit. Maybe the orientation of the screen or pump is off a...
  7. LX302

    I need some help with my driveability issues and codes!!!

    98 (r): Hard fault present. The ECA is running in FMEM (Failure Effects Management Mode), so something is royally screwed up that the KOEO test should have told you about. Rerun KOEO and fix whatever you find there.
  8. LX302

    A/C question, no middle vent air???

    It could be the vacuum line. Get your head into the passenger foot well and look up under the dash next to the center console and look for a vacuum control cylinder, (brass in color). A yellow vacuum line should be connected to the side of it via a nipple. If it is disconnected, you will have...
  9. LX302

    Arm rest delete

    Right on two of them. '87-'89 was "Charcoal Grey" '90-'92 was "Titanium grey" '93 was the "Opel Grey" HTH
  10. LX302

    gets to 1500 rpm then cuts out when in gear

    TPS gone bad?
  11. LX302

    Problems with my 5.0!

    when i turn on the a/c or heater the air only blows out of the vents that defog the windsheild and not out of the vents in the **** pit, and hte air doesnt turn hot, just stays cool. A/C probably need recharging to get cool air. TO fix the venting, look under the dash on the right of the...
  12. LX302

    does water get in your cowl hood

    Sounds like one of your drain holes in clogged.
  13. LX302

    Losing oil AND coolant but no smoke?

    The oil consumption is normal. To burn a quart every 3000 on a low mileage 5.0 is normal. The coolant loss is something you have to look at. If you don't see white smoke and or coolant in your oil, your leaking it somewhere and it's possibly drying up. Don't you smell antifreeze anywhere in...
  14. LX302

    engine stuttering...driving me insane

    When was the last time you did a tuneup on the car? Bad Oxygen sensors wouldn't let the car buck and surge that violently. A good set of plugs, wires, cap and rotor, cleaning the throttle body might clean up this problem. It also could be a bad TPS sensor. Scan for codes after the tuneup...
  15. LX302

    Weird oil issue, any ideas? Look!

    I'm going to ask an obvious question that didn't come up in your question or any of the other posts, but I have to ask. Did you remove BOTH drain plugs on the oil pan? You probably did, but we need to discount it.
  16. LX302

    How to tell if O2s are bad?

    Ok, if the CEL blipped on and then off, you most probably have a stored code in the EEC.
  17. LX302

    How to tell if O2s are bad?

    Scan for codes first before you spend any money. A good tuneup always helps as well.
  18. LX302

    AOD Problem NOT TV cable.

    Does it only happen from the 1st to 2nd shift? Ok, saw that you said is slipped while in first. If you drive down the road and then hit the gas a little, it will slip until you let off the gas a little , then it will shift into second, right? If that's the case, I have a solution for you...
  19. LX302

    swapping seats

    I don't see why not, just bolt the new seat to your seat tracks if it doesn't. Most stangers replace their seats with '94 and up Mustang GT seats. Best bang for the buck.
  20. LX302

    Undercarriage rust

    Depends where on the undercarriage it is, and how much you want to spend on the car. If you want the cheap way, just to keep it nice a couple of more years, then you can do it yourself. I suspect your talking about the floorboards. That sheet metal is pretty thin. But what I would do is sand...
Top Bottom
Back
Forums
Menu