Search results

  1. 7-UP BILL

    Somewhere to get my car tunned?

    Turbo People in Hastings on Hudson, NY THE ONLY place to go with a vacuum cleaner! Job Spetter has tuned cars with turbos well in excess of 1500hp.
  2. 7-UP BILL

    convertible, B springs, and C/C plates?

    I have "C" springs which are basically the same as "B"'s except the front rate is higher on the "C". You may have a bumpsteer problem as the cars before '90 did when lowered. I have Hotchkis "CC" plates on my '90 along with urethane stock style rack bushings. The diff in the '90 and up cars is...
  3. 7-UP BILL

    *Engine won't run right since head install, please help!!!

    Good Call :nice: The stock plugs are short and don't extend into the firing chamber of the Edelbrock heads. The threaded part of an Edelbrock specific plug is quite long. Autolite 3924 is the stock heat range for Edel heads.
  4. 7-UP BILL

    DONT BUY CHEAP ROLLER ROCKERS!...Here's Why..(pics)

    Now how do you feel after the thrill of the low price is gone! :jaw:
  5. 7-UP BILL

    How do you install front spring???

    I heard that! I can't figure out why these guys are having so much trouble. Just lower A-arm all the way down, spring should just fall out, replace spring and raise A-arm w/ jack.
  6. 7-UP BILL

    2nd FLUIDYNE RAD in 2 years LEAKING again?????

    I have a Griffin Mustang specific rad with no problems now in 10 years. Go Griffin
  7. 7-UP BILL

    Help needed with engine tuning

    15 degrees of timing with regular fuel will make it ping.
  8. 7-UP BILL

    Best harmonic balancer for money?

    Fluidampr...10 years and going strong
  9. 7-UP BILL

    Airbag Test Procedure ?

    The diagnostic monitor plugs hold an electrical charge in case the battery is damaged during a collision and allows the air bag to deploy even if battery is disconnected. During a rescue situation we will cut the battery cable then attempt to discharge the air bag so as not to deploy (if...
  10. 7-UP BILL

    90 limited vs 98 cobra

    If I'm not mistaken, Ford made approx 1900 of the Vibrant Red '92 Limited Editions. They made 4,103 of the 7-UP cars. 1,360 were 5 speeds and 2,743 were AOD's.
  11. 7-UP BILL

    FRPP "C" Springs

    seeing as you're gonna have it all apart, spend the few extra measley bucks and replace the control arm bushings. You'll be glad you did.
  12. 7-UP BILL

    timing chain/gear drive

    I have an Edelbrock gear drive. It's not obnoxious ( I do have a blower) as others I've heard. You will need to grind off the chain oiler inside the timing cover. I love it.
  13. 7-UP BILL

    Wheel help in north NJ

    I am in so jersey and we have a great place here in Burlington Twp called Wheel Works. They do bikes and autos. It's on Rte 130 at the corner of Neck Rd. 1 mile south of exit 6 Rte 130 south.
  14. 7-UP BILL

    How do you install front spring???

    I've done FRPP "B" and "C" springs, stock springs, all types. I disconnected "A" arm at spindle. Remember if you loosen or remove the bushing bolts ("A" arm) you must have the suspension "loaded" when tightening bolts or bushings will bind. "Loaded" means having the suspension in driving...
  15. 7-UP BILL

    How do you install front spring???

    It looks to me that you don't have the car up high enough to completely lower the A-arm. I lowered it (arm) almost vertical, slipped the spring into the rear of the perch, used a piece of chain as a safety and jacked up the lower arm with my floor jack. (3-ton). I've done at least 2 dozen this...
  16. 7-UP BILL

    Sparkplug Question.

    If you have stock fuel rails and pump, it is "the end of the line" so to speak. It's hard for the pump to get fuel to those last plugs, so they run slightly lean.
  17. 7-UP BILL

    Cam degree

    I would. Do you absolutely trust the maniac that cut that cam that he did it right? It may have been cut at 1630 on a Friday afternoon. Cabeesh?
  18. 7-UP BILL

    Reardrums to disks with 4 holes

    another JRICHKER Gem. :nice:
View older results
Top Bottom
Back
Forums
Menu