Search results

  1. maypo59

    summit H-pipe?

    I put one on for a friend, no problems. The exhaust seemed to go in one end and out the other, without stopping or leaking out.. so all seems good...lol No idle problems that I have noticed when we were out driving, been about 6 months... It does use a pipe clamp at the "H", I would be sure you...
  2. maypo59

    OT- Should I buy a bike??

    Get a bike? Yes. Get a GSXR as a first bike, No. $100 a month on a brand new gixxer? are they financing it for 10 years, or will the payments go up later (not a good thing, but lots of people buy into this type of loan) Insurance? Just thoughts.. if you save on gas, but have higher insurance...
  3. maypo59

    Good Brakes for a 95gt

    When I did mine, I didn't change the master cylinder, and when my buddy did his, he did. We both think that my pedal "feels" better, and they both stop within 1% of each other acording to the Gtech, sometimes mine was better, sometimes, his... niether of us changed the proportioning valve. He...
  4. maypo59

    clay bar

    http://www.zainostore.com/Merchant2/merchant.mvc?Screen=PROD&Product_Code=Z-18&Category_Code=Zaino
  5. maypo59

    Needed pics of Drilled Brake Rotors for 94-04 Mustangs GT / V6

    There is NO way I would try to cross drill my own rotors. The holes have to line up with the vanes, the whole assembly has to remain in balance, and the heated area around the holes will most definatly fail if the whole rotor is not heat treated and quenched after the operation... There are few...
  6. maypo59

    Stupid Question: 96-98 Tailights in 94-95 GT?

    I think you have to go with what you like.... A previous owner changed mine, didn't even notice untill I had the thing a month, now I am used to them, and think they look fine. and, just because you vave '94-95 taillights, doesn't mean you have a "5.0" anymore than the others mean you a 4.6...
  7. maypo59

    What the hell happened? & Exhaust install questions

    You now are hopefully breathing better (or, your car is, anyways) If your MAF needs cleaned, it will show up, could be your problem. The line you talk about is part of the EGR system, I think. I cut mine so it was a close fit, then put 3/4" hydraulic line over it, with a couple band clamps...
  8. maypo59

    Doesnt Ebay have rules against crap like this???

    Actually it's .... ok, GAY. But I am glad it has front and rear "pampers" so it doesn't get 5hit all over the other Mustangs that might park near it... and, whats with the "9" on the side, hopefully thats not a series number, like a Saleen.. lol
  9. maypo59

    harmonic balencer???

    Your "new motor" was built with a 50oz balance bottom end? Or 28oz? You need a balancer that matches, if thats the problem, make sure you get the right one, your flywheel also must match the balance of the crank. Also, did you index the bellhousing to the new motor? Just some thoughts...
  10. maypo59

    Lets Talk Front Brakes

    If you shop around you can find new 13" front kits for $299-399, and rear kits from Baer are around $199.. Mine were about $600 for all four corners, with SL/CD rotors. The Cobra's will NOT fit under a 16" wheel. Tried it just to see. I autocross with the local SCCA club, go every other month...
  11. maypo59

    steering wheel play in column

    It would seem to me that welding the slip joint would be bad.. It's there to keep the column from becoming one with your chest in the event of front end collision, and, it would make it a lot harder to change the rack and stuff when you need to. IMHO.
  12. maypo59

    (ABS)?

    Or, you had some air trapped in your lines, and when you compressed the caliper pistons, you pushed it into the ABS valve.. bad. can't be fixed by just bleeding the old fashion way. It needs to be bled with a special tool in place to open the ABS valve while bleeding. If you can't find any other...
  13. maypo59

    What Pressure does A/C Compressor Come on?

    IF it was completely out, it will take more than one can to bring it up to the proper amount of R134a. If you are seeing 85-90 psi on the LOW preasure side, which is the side under the brace on drivers side, there is something else wrong with your system. You might try jumping the switch on the...
  14. maypo59

    carfax check

    Ummm... a 95 will show up to 999,999 miles before it rolls over.. or , at least mine will.. shows 113,xxx right now. I have always been a little scared about cars that suddenly get a Florida title.. they have some kind of odd title procedures down there when it comes to wrecks and stuff...
  15. maypo59

    1995 mustang ac

    most probably vacume line from engine bay to door that controls flow.
  16. maypo59

    Car died yesterday, need help on this one

    I got one from summit, it's accel, was $49. I live close to them and stuff gets here overnight.
  17. maypo59

    Vortech

    According to the instructions, you will have to tap the oil pan. I am guessing you leave the line above 3500 rpm, which is about where they start building power it looks like..
  18. maypo59

    DO NOT BUY!!!

    I got my Cobra brakes from them, not only did I have no problems with the order or process, when I was installing them I ran into a problem, called, and they talked me through it. Sad to hear you had a problem with them. I would bet they will make it right. BTW, the SS brake lines for the...
  19. maypo59

    Dirt Bike, Wheels, H/C/I, Save???

    If you are carefull about the "sport bike" you choose, the insurance can be easy to handle if you keep a clean record. Don't get anything with R or RR or most definatly not RRR in the name, many great sport bikes out there without. I have Superhawk and a RC-51 in the garage, one for street...
  20. maypo59

    OT: Rice or not

    I also belive that if you like it run with it.. It is YOUR car after all, but may I point out, orange neon under your 'stang, may in fact, be rice. Not 'cause it's neon, 'cause it's color coordinated! Just kidding if that's your car... :-)
Top Bottom
Back
Forums
Menu