Search results

  1. Jason 302

    V3 Installed!!! Lots Of Pics

    Good to know, thanks. I would like to stay with a 245/45-17
  2. Jason 302

    V3 Installed!!! Lots Of Pics

    The car was a torque monster even before the blower, made a little over 340rwtq. I credit the AFR 165s, Performer intake, and putting the Trick Flow #1 in +2 for that. I really need to invest in some Nitto DR's. The car doesn't go out if rain is in the forecast. How many miles do people usually...
  3. Jason 302

    V3 Installed!!! Lots Of Pics

    I should really take a scan of the print out but it's out in the garage and I'm too lazy, so here's a picture of the computer screen. 479.8rwhp 472.1rwtq 13lbs of boost @6000rpm :O which is a little more than I was expecting lol Had just a few small issues. First issue was the supercharger...
  4. Jason 302

    Anybody Drive Their Power Piped Car In The Rain?

    Inner fender splash guard is installed, but there is a decent sized opening right behind the fog light area from the factory. I thought maybe, since it's a low pressure area at speed, some rain mist might get sucked in. Update, the car did wonderful, even had to weather a little bit of slushy...
  5. Jason 302

    Anybody Drive Their Power Piped Car In The Rain?

    I'm sure I'm just being paranoid. The thought of mists of water hitting my brand new impeller and making it rusty gives me nightmares lol.
  6. Jason 302

    Anybody Drive Their Power Piped Car In The Rain?

    So I have to take the car to the dyno tomorrow to get it tuned since the addition of the supercharger. Rain looks very likely. My car hasn't seen rain in about 8 years and I'm dreading it. My question is, with the power pipe putting the air filter and MAF down inside the fender well, should I be...
  7. Jason 302

    Fox Trick Flow Lower Leaks Antifreeze Next To Distributor

    Check the by-pass hoses also. They run from the water pump to the thermostat housing and also from the water pump to the heater pipe. Check upper radiator hose and thermostat housing gasket. If those aren't it, it may be coming from the intake gasket manifold which means you will have to take...
  8. Jason 302

    Pony's Versus Saleens...

    I have to agree with this. This is why I went with Mavromont PonyR's when I was still 4 lug. The center cap covers up the lugs.
  9. Jason 302

    V3 Installed!!! Lots Of Pics

    Thanks, that's what I plan on doing. Heck I was even thinking about 5500 rpm max during tuning, with just a couple runs to 6K. Dart block 331 plans are in the future, but I would like to fund a few other things before I have to go there. Fuel lines & rails, aluminum driveshaft, full length weld...
  10. Jason 302

    V3 Installed!!! Lots Of Pics

    I'm hoping that's not for a few years lol
  11. Jason 302

    V3 Installed!!! Lots Of Pics

    That's about what I'm shooting for. 450-475 rwhp @ 10psi. I will find out Thursday I guess.
  12. Jason 302

    V3 Installed!!! Lots Of Pics

    I know, I was just curious :). I probably won't even start the thing again until Thursday.
  13. Jason 302

    V3 Installed!!! Lots Of Pics

    Belt alignment is good, just trying to find the perfect length belt. The Schrader valve was digging into the elbow before I tweaked them (fuel lines), they should be good now.
  14. Jason 302

    V3 Installed!!! Lots Of Pics

    I'm thinking about going the easy route and buying an idler pulley/delete kit for the a/c compressor lol.
  15. Jason 302

    V3 Installed!!! Lots Of Pics

    Just installed a brand new Vortech V3 Si Trim last week, just been making some small adjustments to it to get it ready for a custom dyno tune next Thursday. Install went pretty well, biggest PITA has been getting the power pipe to fit correctly, and finding the proper sized belt. Aeromotive...
  16. Jason 302

    Water Hose To Alternator Too Close ?

    Advance Auto show their upper hose coming with one, it's only $14. I would just pick one up. http://shop.advanceautoparts.com/p/carquest-by-dayco-curved-radiator-hose-c70965/5197228-P?searchTerm=radiator+hose+-+upper
  17. Jason 302

    Guess My H P !!! - The Dyno & 1/4 Mile Time Thread

    I'm getting ready to put a V3 on my HCI 306. Those are exactly the numbers I'm looking for.
  18. Jason 302

    Siemens-deka Reman 42lb Injectors

    I've heard of Siemens-Deka and I'm sure they're leaps and bounds better than the knock off China crap currently on eBay. No way I'm buying those things. I wanted to find a good set of Bosch 42's which I believe came originally on the Lightning, but they're getting hard to find. I guess my...
  19. Jason 302

    SOLD Mavromont 17x8 Pony R Rims & Tires (4-lug)

    $750
  20. Jason 302

    Anybody Running An Aeromotive 16307 Wiring Kit?

    Okay, so the wire that's already back there should be okay for the trigger wire. It's only 10ft long, will it reach back there if I mount the breaker and relay in the engine compartment? I'm curious as to why they mounted both in the hatch in the article, when the instructions say to keep them...
Top Bottom
Back
Forums
Menu