Search results

  1. asecretfile

    It's official, I hate EFI!!!

    Copied from another site __________________________ Mechanical Changes Intake and Carburetor: Of course if you are converting from EFI to carb you must have an intake manifold and a carburetor. Just be sure to size the components to match your combination properly. Fuel System: You...
  2. asecretfile

    Bad fuel pressure regulator??

    bump
  3. asecretfile

    Bad fuel pressure regulator??

    87 Mustang GT carbed...noticed my exhaust started smelling rich and I checked the fuel pressure (holley fpr has a gauge threaded in) and it was at 10psi :jaw: Last I set it was at 6psi and when I went to lower it, it wasnt loose like it had backed the screw out or anything :shrug: When it...
  4. asecretfile

    Idle/Rev Clips Post 'em Up!

    thanks, when I had tailpipes put on last week I was worried I would lose alot of the sound but I like it better. It seemed like with the dumps I had before made any muffler sound about the same :shrug:
  5. asecretfile

    Check out this gem (pic)

  6. asecretfile

    Idle/Rev Clips Post 'em Up!

    another one...and no I still havent taken down my Christmas lights yet lol :rlaugh:
  7. asecretfile

    Check out this gem (pic)

    dont worry, wheel size decal...check! 22's
  8. asecretfile

    Check out this gem (pic)

    Not a Mustang but I found it worthy of a chuckle...cell phone pic in a parking lot :nonono:
  9. asecretfile

    Idle/Rev Clips Post 'em Up!

    :cheers:
  10. asecretfile

    Idle/Rev Clips Post 'em Up!

    I think it sounds much better with tailpipes
  11. asecretfile

    Car towing??

    well, towed it in neutral with no problems. not saying it was ideal but I did however in addition to having it in neutral, I used a piece of wood to hold down the clutch pedal. Not sure if that helped or hurt but did it anyways :shrug:
  12. asecretfile

    Car towing??

    87 Mustang GT 5 speed Will it hurt anything if I tow the car with the front on the tow dolly with the car in neutral? Going to be towed about 15 miles My front end sits pretty low and will scrape just about anything if I raise the back of it onto the dolly thanks
  13. asecretfile

    Idle/Rev Clips Post 'em Up!

    had a problem with gas shooting out of my fuel bowl vent so I pulled out the needle and unlodged this obstructing the needle from seating, tiny little piece of fishing line type debris :fuss: but anyways, heres a clip before getting new exhaust installed tomorrow :nice: Getting...
  14. asecretfile

    Gas on Air cleaner??

    yea its right under the hood before the carb. Now with all new plugs, its misfiring at low rpms (most noticeable about 1500) but smoothes out when I mash the gas further :shrug:
  15. asecretfile

    frooze???

    was it out of gear? Ive caught myself trying to turn it while it was in gear, forgetting to throw it in neutral :shrug:
  16. asecretfile

    Gas on Air cleaner??

    I bought the carb brand new in December...Holley 650 double pumper...and now its just April and this is happening. Its past the 90 day warranty but the store manager said he's help me out. Im just going to have him order me a new one
  17. asecretfile

    Gas on Air cleaner??

    tapped the float and it quit doing it. Now my new plugs are soaked in fuel. Just take them out and let them air dry?
  18. asecretfile

    Gas on Air cleaner??

    Gas pouring out of Carb?? Been trying to figure out a bogging issue when I took off my air cleaner and it was soaked in gas...it poured out. What would cause that EDIT: Turned on my fuel pump with the engine off and gas is just POURING out of this any ideas?
  19. asecretfile

    Fair price...tailpipe addition??

    Tired of the fumes and interior drone....I dont have a welder, so what would be a fair price to have a local muffler shop hack off my turn downs and weld in these tailpipes? I will have the new tailpipes with me when I go which already have the hanger bar and I bought new hangers/isolators to...
  20. asecretfile

    Electric Fuel pump problem??

    I have a Holley Blue electric fuel pump wired in with a 7.5A fuse per the instructions. After replacing that fuse about 7 times I got sick of it and wired it straight in on a toggle. Heres the weird part. For the past 2 mornings on the way to work it blows the fuse at the same place at the same...
Top Bottom
Back
Forums
Menu