Search results

  1. Dan02gt

    Exhaust PACKED THERMACTOR HEAD PORTS?

    I would just run it like it is for now. LMR makes a factory style replacement H pipe you could get if your factory cats fail. I’m not sure how you would fix the issue with the clogged ports in the heads without removing them.
  2. Dan02gt

    17x10 rear wheel

    I’ve got the ponies in 17x9” with a 275 tire and it’s perfect. I did nothing to make it fit, not even flipping the quad shock. If you’re planning on running a 275 I don’t see what the 10” wide will gain you over the 9”.
  3. Dan02gt

    Electrical What's inside a TFI module? (Gut pictures inside)

    I agree. I've always though highly of Delphi products.
  4. Dan02gt

    Electrical What's inside a TFI module? (Gut pictures inside)

    Here’s a picture of the new Delphi that gave me a slight miss-fire on occasion.
  5. Dan02gt

    Electrical What's inside a TFI module? (Gut pictures inside)

    The McCully Racing kit. http://www.mccullyracingmotors.com/index_files/Page2271.htm
  6. Dan02gt

    Engine Running hot and driving me crazy

    I have the factory 195* thermostat and mine sits right on the A when warmed up. When I read the engine temp via the ECT using my Quarterhorse the A is ~185*.
  7. Dan02gt

    Electrical What's inside a TFI module? (Gut pictures inside)

    Mine died on me this past summer driving almost 50 MPH. Car just cut off!! I was fortunate that traffic was light and I was able to get over to the outside lane and coast into a parking lot. After about 15-20 minutes with the hood popped it started up and I was able to drive home. Mine had...
  8. Dan02gt

    Digital Tuning Data Logging with EECIV????

    I researched a lot before getting a Quarterhorse. I looked at MS, Holley, and Pro-M. My requirements were: must maintain Mass Air and must maintain sequential fuel injection. I ended up going with the QH because it met the above requirements plus it's cheap and easy to install. My engine...
  9. Dan02gt

    Exhaust Looking for different catback exhaust.

    I’ve heard decent ones. The issue is the rear mounted mufflers eliminates the tail pipes and that totally changes the sound and not for the good. I had a off road Pro-Chamber and the Flowmaster axle back on my 2006 GT and it was loud but had a nice deep tone to it and was not obnoxious. On my...
  10. Dan02gt

    Exhaust Looking for different catback exhaust.

    I’ve never heard them either, but a stock fox with a stock H pipe isn’t going to be very loud no matter what cat back you install so I wouldn’t worry to much about that.
  11. Dan02gt

    Engine Intake, throttle body, mass air combo

    I those same valve covers with a cobra intake and didn't need any spacer for it to clear. All you need to do is notch the bolt holes in your throttle cable bracket a little bit to allow you to slide it up a higher to clear the valve covers. I did buy a 3/8" spacer but didn't use it due to...
  12. Dan02gt

    Fox Upgrading the Fox Body factory Head Unit and Speakers

    Here's my little 10" with the amp mounted to the sub box. To access the spare tire you just lay the seat down, unclip the hold down strap, and roll it forward. Now the 2 12"s I had in my high school years were a different story. The sub isn't required if you don't mind less bass. A good set...
  13. Dan02gt

    Fox Upgrading the Fox Body factory Head Unit and Speakers

    Yes it can. Component set for the front stage. Tweeters in the dash in place of the 3.5”. Make sure they are on a gimbal mount that allows aiming. 6.5” or 5.25” in the doors. Add some power a little sound processing throw in some time alignment and a 10” sub with 200-300W and you would be...
  14. Dan02gt

    Digital Tuning Data Logging with EECIV????

    That's what I heard too and that's why I went with the QH over the Tweecer. Here's a screenshot of my dashboard setup:
  15. Dan02gt

    Digital Tuning Data Logging with EECIV????

    I have the Moates QuarterHorse and it can easily do what you are asking.
  16. Dan02gt

    Fox Upgrading the Fox Body factory Head Unit and Speakers

    I have an Alpine head unit in mine with the 4x45w RMS power pack amplifier add on. It operates "inline" with the wiring via Alpine harness that plugs into the back of the head unit and into the factory wiring. It powers a pair of 5.25" components with the tweeters located in the dash in place...
  17. Dan02gt

    Fox Chrome pony wheels, what size?

    I have that same setup on mine just in the factory silver. The fit is perfect. Man they have gone up in price since I bought mine in 2016.
  18. Dan02gt

    Complete shut down w/code C-18

    You might have already covered this but check the power and ground wires on the 60 pin ECU connector. Mine had a issue where you could just touch one of them and the car would shut off. I ended up buying a new 60 pin connector and swapped them, tightening each physical connection as I moved it...
  19. Dan02gt

    Fox Body Shocks/Struts and Lowering Springs thoughts?

    Here's mine setting on Steeda Sport springs. I have the Koni SRT.T shocks and struts, but I've heard the KYB GR2s are decent for the money. I also have MM adjustable lower control arms so I can raise or lower the rear of the car from where it sets in this picture.
  20. Dan02gt

    Long Tubes Worth it for my build?

    They will make more power, but they are a pain to deal with when you need to work on your car. Like Monkeybutt2000 said go with the 1-5/8".
Top Bottom
Back
Forums
Menu