Search results

  1. 6

    Arms

    Street car. I don't like the screw on pivit ends on the stock arms. Mostly a personial quick.
  2. 6

    Arms

    I think that says it all.
  3. 6

    Arms

    I am looking for tubular arms (at least upper) to replace the factory stamped arms on a 66, that do not cost as much as global west arms. I want to keep the stock springs. Anyone know of any? I would consider some kind of a shaft replacement for those screw on pivets on stock arms. Thanks guys
  4. 6

    Caltracs???

    Here www.hotrodsandhemis.com/Traction.html Make me a set while you are at it.
  5. 6

    New waterpump problem

    Just bend that one blade up a hair untill it doesent hit anymore.
  6. 6

    anyone actually rebuilt their rear themselves??

    If using the same r&p, not to much trouble. You do need a bearing puller. Have machine shop remove and replace the axel bearings.
  7. 6

    We Have Calipers!

    Brakes Where did you find your ss brake pistons and how much.
  8. 6

    C4 tailshaft bushing

    New bushing If the bushing is installed correctly, the yoke will slip back in. The c4 bushing is long and you have to have the correct bushing driver or the bushing will swell on the ID..
  9. 6

    Mystery hose

    Vent Rear axel vent.
  10. 6

    Gotta Tune this Sucker, HELP!!

    Rich Are you using a big electric fuel pump without a regulator. What amount of vaccum are you pulling, use a power valve lower than this amount. Maybe just use the lowest you can find.
  11. 6

    Aluminum driveshaft info?

    Driveshaft I think you should be alright with stock, shortened if necessary, driveshaft. They are overdesigned , if not they would be known for failure. If you are using slicks and dragracing, maybe not.
  12. 6

    Head Gasket Installation

    Sealer Install either dry or with the silver paint. I perfer the silver paint and have used this on all high compression engines.
  13. 6

    Idle Speed Fluctuates

    Does your carb have a power valve, could be opening causing more fuel flow, what is the vaccum readings.
  14. 6

    Need Help, Pistons binding.

    No No You should not use locktite on rod bolt or bearings. Any bearings damaged should be replaced not straigntened out. I would remove all the rods and clean them and the bearings. Use engine oil on the threads or your torque readings will be thrown off and you will never know the real torque...
  15. 6

    Are composite leaf springs worth it on a street ride?

    Weight I have been told that 225 lbs have a lot of bounce. That is why I was asking what Boo Boo Foo used. But I think that Edbert is in the ballpark.
  16. 6

    Are composite leaf springs worth it on a street ride?

    Springs What specs did you ask for in spring weight as far as supporting the rear of car.
  17. 6

    AOD swap where do you start.

    AOD is the way to go.
View older results
Top Bottom
Back
Forums
Menu