Search results

  1. Trublu01

    Flows?

    Looks good to me. I'm running MAC LT, O/R X and welded in 2 chambers and I love it.
  2. Trublu01

    From 4.6 to 5.4

    Al Palpito is running a built 5.4 in his cobra, all motor running mid-low 10's.
  3. Trublu01

    To Mod or Not to Mod???

    If your gonna stay N/A then 4.30's all the way
  4. Trublu01

    To Mod or Not to Mod???

    Well looks like your plans are to S/C so forget pullies. If you have "pluthra" of money for mods, get a 12-14 psi S/C, Exhaust, suspension and gears. your done! (Cobra)
  5. Trublu01

    rear differential

    Ford 8.8, 28 spline diff.
  6. Trublu01

    Please help reinforce my decision...

    Don't worry, rock n roll ain't noise pollution!
  7. Trublu01

    Clutch Squeeling.. Help please

    Throw out bearing. Remove the access panel on the tranny (where the cable goes in) and spray some White Lithium Grease up in there on the TOB.
  8. Trublu01

    What's Your Exhaust Set Up's

    MAC Jet Hot LT, Trubendz O/R X Pipe and 2 Chamber Flows, Dumps soon!
  9. Trublu01

    Installed chip and now car wont start

    If the theft light is blinking, the chip is not programmed properly for you code (PATS) Dump the chip anyways. I have seen with my own eyes a Diablo chip tunned and retunned and then one more tune by Willie, the car gained HP and TQ about 7-10, but lost almost 1/2 second at the track. We...
  10. Trublu01

    need help with eibach springs

    You should have no problems, just replace them when you can.
  11. Trublu01

    2002 cobra???

    no 02 Cobra
  12. Trublu01

    T/A very necessary for ud pullies

    WELL WORTH the money!
  13. Trublu01

    Taking the trans out

    Did it from under the car!
  14. Trublu01

    99+ Cars with 4 cylinder FOX springs up front

    4cyl springs up front is for a drag racing application, if you cut the fronts you'll be messing with weight transfer, which will make the whole process worthless. The drop is fine.
  15. Trublu01

    Dr. Gas X installed - sound clip inside!

    Sounds good, I guess you'd hold a hard-on in my car! MAC LT, O/R X and 2 Chamber flows.
  16. Trublu01

    Rear-end parts!?

    Just tell him to spend about a G for an Eaton Posi, 31 spline axles, studs and gears, then throw the slicks on.
  17. Trublu01

    H Pipe OR X Pipe LT's

    MAC Lt and Trubendz o/r X pipe, made for MAC's
  18. Trublu01

    Taking the trans out

    I had someone with small hands do it with a multitude of tools. sorry.
  19. Trublu01

    99+ Cars with 4 cylinder FOX springs up front

    No cut the 4 cyl front springs. Most cut rear V8 Fox springs.
  20. Trublu01

    Taking the trans out

    Bingo, the passanger one huh? it's a mutha humpa
Top Bottom
Back
Forums
Menu