Search results

  1. 67bluestang

    Minitub ?'s

    You mentioned 4 link and moving leaf springs in for clearance. If you're going to a 4 link, you can't run leaf springs, you'll need coil overs. The rear end has to be able to rotate a certain amount and the leaf springs prevent this.
  2. 67bluestang

    Tube Chassis for 68

    Actually, i don't think it would take anymore work to attach the steel body vs the glass one. It was a real pain when i built my trans am. Trying to find a good place to attach a brace, then fiberglass it in. On a steel body, the braces could be spot welded in place, plus the rocker panels...
  3. 67bluestang

    302 water pump and timing chain questions

    Thanks for the info. That's kinda what i was thinking about on the t/c setup.
  4. 67bluestang

    302 water pump and timing chain questions

    I've got a 67 Coupe with a 302 and according to the numbers on the block its from a 78 Lincoln. The water pump lower hose is on the drivers side, so i assume a 72 and up w/p is what i should use. Are there any differences between the 72 vs 78 302 timing chain setup? Should i just buy the...
  5. 67bluestang

    How to get a 67 coupe into the 10's?

    1. MONEY 2. Put it on a diet 3. Good rearend 4. 3500-4000 stall convertor 5. Big block 6. MONEY 7. Roll cage 8. Safety equipment 9. Slicks 10. MONEY
  6. 67bluestang

    Need 4 link pics/opinions

    I think a set of Caltracs or slapper bars would be more than sufficient. If you're not going to modify the rear subframes for larger tires, why go to the expense of a ladder bar setup. If you do go ladder bar, be careful when welding the brackets on the rearend. The added heat can pull the...
  7. 67bluestang

    Rearend questions - trying to put a 9 inch in a mustang

    Ford4fun, Here's a picture of a 4-link rear clip assembly from the art morrisons site. 4-link clip Its a lot of work putting the rear subframe assembly in, but it sure is a nice setup when finished. There are numerous options as far as floor, wheel tubs etc. The tubing used for...
  8. 67bluestang

    Need 4 link pics/opinions

    Is the car backhalved or stock subframe? If you're planning to go 4-link, i would say backhalve the car and get a good frame under it because the 4-link brackets need good/strong places to be welded in and most stock subframes won't work for that. I'm not sure what kind of bags you're talking...
  9. 67bluestang

    Later model Mustang mini starter in 67

    I found the following about this: Looking to replace that old heavy starter on your 3.8 litre V6 or 5.0 V8 Fox Capri? A good replacement is the 93-95 Ford Mustang 5.0 starter. It's smaller and lighter. It also has a higher torque rating to start your motor. The '93 starter's wiring is...
View older results
Top Bottom
Back
Forums
Menu