Search results

  1. M

    Small squeek behind dash when driving.

    haha ive de-squeaked my car, its pretty easy really. I had the same squeak behind the dash, and mind turned out to be a piece of the plastic dash behind the gauge cluster rubbin on the steering rod. I just shoved a piece of rubber in there and no more squeak! Other common squeaks ive found is...
  2. M

    HELP: clutch will not disengage!

    stock quadrant? when i did my clutch and all that stuff after i was done i lifted up a little on the clutch pedal and stepped down and heard a clunk and now it works fine. Id give that a try
  3. M

    Speedometer Gear Question

    Alright ive seen the table with all the speedometer gears and which ones too use, but does any1 kno how accurate any of that is? Hanlon Motorsports has a calculator on their website, and it doesnt match up with that table, and im not sure who to believe
  4. M

    Installing shocks at home

    if ur throwin away the old struts and dont have an impact, i did mine by clamping a pair of vice grips on the rod, and i mean clamping, i jumped on the handle to close them, and then just hold them and loosen the nut, it was easy after that. For the new ones i just used a screw driver in the...
  5. M

    a NERVE RACKING RATTLE AT 5 MPH TO 35

    i had a horrible rattle coming from the hatch, turned out to be that plasic cover that goes on the bottom of the hatch, it was loose, i stuffed some foam behind it and problem solved.
  6. M

    Incredibly weird engine problem. No SEARCH function will help me out!

    headers are glowing red, wouldnt that indicate a lean condition? try playing with the fuel pressure, i think 24s at 40psi might not be enough fuel, also check to make sure the injectors are fully seated, and you could even pull the plugs too see if its firing on all 8.
  7. M

    Before and after

    i got some pics, but ive only had my car about 8 months now, and bein 19 with two cars leaves little money for upgrades =/ heres what it looked like the day i got it and heres a couple recent pics oops little big hunh? hehe
  8. M

    bbk t body whistleing: any way to stop it

    i have a bbk throttle body, and it doesnt whistle! I found that with the iac disconnected, it whistled no matter where i set the idle. However, with the iac connected, i was able to adjust the idle a little higher, and it stopped whistling.
  9. M

    Prayer for a Mustang God

    one of your codes is the evr failure, which controls the egr valve, if that was going bad, could it engage/disengage the egr valve at the wrong times possibly? more of a question
  10. M

    Pro5.0 Shifter Problem

    nah i kno that 2nd is shot, i took the stop bolt out and took it for a drive, it still pops outta 2nd, but usually only on downshifts. with a 116k on it, im not surprised, i kno the previous owner beat the $*#*)(@ outta the car. Thanks for the tip about the grease tho, it kinda worried me.
  11. M

    Same Old Question!@! Idle Problem

    i had a similar problem as to what your describing, and it turned out the previous owner had cleaned the throttle body, when it had that do not clean sticker, which cause the blade to stick slightly open. Try cleaning out the IAC real good, and check the tb to make sure it closes all the way...
  12. M

    Pro5.0 Shifter Problem

    Alright, i searched around, and couldnt find anything like my problem, so here goes The Pro5.0 shifter i bought came packed full of grease, and i installed it like that. After installing it, my transmission slowly started poping out of 2nd gear more and more, and i figured it was time for a...
  13. M

    EVR

    well in your original post you ask about the EVR, which jrichker explained applies vaccum to the egr valve based on load and rpms, and always has vaccum applied to itself. However, what you describe in later posts sounds like the charcoal canister. I think you confused everyone, try typing out...
  14. M

    The Quest for Ground Clearance

    the drag springs probably make the front reallly soft, and the front would dip down quite easily i would think. Also, are the struts originals? new struts could help a little And more as a question, when motor mounts get old and start to fall apart, could that cause the engine to sit lower in...
  15. M

    After a near accident, What makes Fox brakes so bad?

    the reason i think most people say the fox brakes suck is not the first or second stop, its the repetitive stops on the track, Fox brakes fade away quickly. Ive honestly never had a problem stopping in time, and i live in jersey, where people love to pull out in front of you in a 55 and go 20...
  16. M

    Speedometer way off

    well if the old face is still on underneath, then most likely the person left all of them on. You might be able to remove all the overlays and just go back to the stock black gauges for the time being, if the 85 mph speedo is something you can live with.
  17. M

    I finally got new rims

    they are from O.E wheels in cali, i bought them off ebay.
  18. M

    Speedometer way off

    what im thinkin happened is the previous owner put a 140 mph face on top of an 85 mph speedometer, if u take the cluster out, try lifting up on the edge of the white faced overlay, if you see a black one underneath, try to see if it goes up to 85 or 140.
  19. M

    I finally got new rims

    Ok, so i got the rims like 2 months ago, but i dont have a digi camera Here is one veeery dirty picture of what the car looks like now Comments? i kno the hood is big, but no matter how much u guys cry/complain/whine, its staying
  20. M

    Speedometer way off

    hmm didnt 88 have the 85 mph speedos? Does the white faced gauge he put on go up to 140?
Top Bottom
Back
Forums
Menu