Search results

  1. madspeed

    Progress Thread Tanner's "there's Probably A Name For This Illness" Builds Thread

    Saw this on the Z06 fb page, looks like a c5 was copying you
  2. madspeed

    94 Gt Acceleration Problems/under Load

    nah you're stuck with me :D
  3. madspeed

    Build Thread My 1986 T-top Build - Lasting Memories

    welp, I was wrong, guess that means is time for a cold one!
  4. madspeed

    Build Thread My 1986 T-top Build - Lasting Memories

    my guess is that it is now nappy nap time
  5. madspeed

    Help With Driveline Vibrations In 88gt

    ok, that ca rule out flywheeissue unless your motor was rebuilt and balanced differently
  6. madspeed

    Replacement Ps Pulley

    if the pump is being replaced as well, why not go to your local parts store and but a new or rebuilt unit with pulley intact
  7. madspeed

    Engine Knocking Sound From Upper Intake Or Dside Valve Cover

    any marking to the underside of the valve vover? could be a rocker touching the vc
  8. madspeed

    94 Gt Acceleration Problems/under Load

    find a new helper in that case
  9. madspeed

    Help New To Foxbody

    meh, maf conversion and vortech kit! 400 hp and stock characteristics until right pedal pressed hard
  10. madspeed

    Help With Driveline Vibrations In 88gt

    you mean imbalance? ie 28oz, 50 oz or zero balance
  11. madspeed

    Radio Setup

    different vehicle, but simar situation. The fox can be fit with a double din. I just installed a chinese bmade Pumpjin branded doudle din into my daily driver. All 100% android, with nav, reverse cam, bluetooth etc. All told, cost less than $300. very happy with it
  12. madspeed

    Pulling A Head

    yes
  13. madspeed

    94 Gt Acceleration Problems/under Load

    fix your known isues(egr etc), locate ant vaccum leaks and gix them. Then perform base idle reset, and run all your codes. This will let the computer tell you whats goung on. I'd say from experience that the 94 computers are a bit finicky when it comes to swapping maf's and injectors. They also...
  14. madspeed

    Looking For Info On Carlisle Pa Mustang Show

    it is, especially the Fall general automotive show, but I still prefer the Ford show
  15. madspeed

    Head Gaskets

    ford decided your money was better spend on them when you blew your head gaskets
  16. madspeed

    Engine Rev Engine To About 3k And It Bogs Down

    copied from @jrichker can also be viewed from the sticky posted at the top of the fox tech section.... Dump the codes: Codes may be present even if the Check Engine Light (CEL) isn't on. Dumping the computer diagnostic codes on 86-95 Mustangs Revised 26-July-2011. Added need to make sure...
  17. madspeed

    Looking For Info On Carlisle Pa Mustang Show

    I've always just parked right there on the fairgrounds. Might cost a few bucks more, but very convenient. If you've never been to Carlisle, you'll be overwhelmed!
  18. madspeed

    Engine Rev Engine To About 3k And It Bogs Down

    codes??
  19. madspeed

    Preformance Suggestions And Advice Needed

    Post up those queationsover in that model specific setion and you'll get some help from the guys experienced with that platform. My experience says a throttle body change will gain you nothing without other mods, typically heads, cam, and intake before throttle body
  20. madspeed

    Back Again.

    paint, ah keep it a sleeper!
View older results
Top Bottom
Back
Forums
Menu