Search results

  1. D

    jrichker, I got one for ya! Anyone?

    haha i have all new harnesses in my car and swapped over to newer style dash and interior. no way its going to the scrap yard, lol.
  2. D

    code 67, is it legit?

    I cleared my code and then ran my car for about 10 minutes and checked code and it was throwing a 67 as a hard code. now the car surged and died and stuff and i just left the key on and checked my tps voltage with a voltmeter from the green wire straight to ground, could that cause it to throw...
  3. D

    should i alter my gas tank?

    haha thanks.
  4. D

    jrichker, I got one for ya! Anyone?

    i have tried to change the global fuel and idle fuel up to 40 percent with the pms and it will hardely change anything to the A/F. I know its not the pms at fault cause it had this super lean a/F before I installed it. Its crazy, reading super lean but the exhaust smells really really rich...
  5. D

    should i alter my gas tank?

    mine doesnt have that plastic shield. hmm maybe i could just hammer the seam flat or something. Its crazy that nobody has ever run into this prob with big tires. I tried searching and nothing!
  6. D

    should i alter my gas tank?

    I have 295/50/15's and its pretty much impossible to fit tailpipes on my car. My gas tank is too wide to even get a 2.5 pipe by it. I was thinking about taking my gas tank off and then cut the ends off about 2 inches closer on each side and weld a plate on each end. Im not really worried about...
  7. D

    pms problem?

    check and see if your pms is throwing codes, from the main screen press the next button.
  8. D

    jrichker, I got one for ya! Anyone?

    the o2's are brand new
  9. D

    jrichker, I got one for ya! Anyone?

    Yes I understand that, My symptoms are from running too rich, yet my A/f ratios are very lean, its crazy. I got a code a few months back that says I hit my adaptibve lean limit. This would make sense being that the comp is reading too lean and trying to compensate by richening the mixture...
  10. D

    jrichker, I got one for ya! Anyone?

    I replaced all the harnesses in my 86 with ones out of a 90 and 91 gt. The car runs and drives fine but my A/f ratio's at idle and part throttle are ridiculous! It averages about 18:1 and gets as rich as 16:1 if im lucky. Ive done a lot of datalogging and the WOT ratio's are dead on and...
  11. D

    spec or clutch masters ?

    haha alum flywheels arent a waste. Your car revs noticably faster but the downside is to compensate for the loss of weight you need to rev a little higher to build more momentum when launching. There was a thread on this a while back but someone did some math and found out that its easily less...
  12. D

    spec or clutch masters ?

    spec stage 1 or 2 with alum flywheel.
  13. D

    Granatelli Lowers worth the price?

    i bought granatelli uppers and lowers and havent had any prob with them except! that i had to narrow my rear swaybar.
  14. D

    The dreaded tick

    you know ive heard, people cut the top of the stock vc's and start the engine up like so engine wont go flying off the sides and you can look down at the rockers. makes adjutsment soooooo easy.
  15. D

    power window setup, think im missing something

    some of them have it and some dont, wanna sell just the spring? ill pay for shipping!!
  16. D

    Ngk Wbo2

    nope doesnt datalog, doesnt even send out a narrowband simulated signal neither. innovative lm-1 with rpm converter is the best deal imo.
  17. D

    power window setup, think im missing something

    yeah thats what ive heard, thanks a lot for the advice..ill be careful. mine doesnt have a spring but like you said ive heard some do come with them. I talked to a local ford perf shop and they said that they really dont aid the window when the motor is lifting it up. anybody else have any...
  18. D

    power window setup, think im missing something

    come on
  19. D

    power window setup, think im missing something

    My pass window doesnt go up smoothly and sometimes will get bogged down so muxch itll stop a little more than halfway up. Ive tried greasing the tracks and everything, adjusting the motor. I finally took the motor assembly out today and on the back of the big arm that goes to the slider there...
  20. D

    Just finsh ordering a DCContoler!!!!

    im pretty sure that the mk8 would be cheaper than the viper fan but I may be wrong. I bought mine from houston performance for 130 over a year ago Drew
Top Bottom
Back
Forums
Menu