Search results

  1. Aaron 4.6

    300 rwhp...is it possible NA?

    Well, its logically impossible to PROVE that something CAN'T happen, but I think trying to squeeze 300 rwhp out of a 4.6 2V using natural aspiration and no major induction changes is going to be close to impossible. There's no reason why you can't get into the 250-260 rwhp range using most of...
  2. Aaron 4.6

    Help..asap!!

    No soup for you. Sucks.
  3. Aaron 4.6

    351 swap, to expensive to be done or not to bad

    I would think a crate 99/01 Cobra motor with a few bolt-ons would be at least a hundred hours of labor cheaper and a couple thousand less bucks. One of my good friends in Augusta has a 99 Cobra (one of the crappy ones, right?) and is putting down 330/330 naturally aspirated. Full exhaust...
  4. Aaron 4.6

    Help!!!

    Motor Switch (not likely unless the passenger switch is slaved to the drivers... but it is in some cars) Relay I would try to get to the motor and jumper a 12v source to it. If the motor is good it will at least get the window up until you can fix the problem. If the motor is no good...
  5. Aaron 4.6

    can any one tell me what a short block is??

    short block = lower rotating assembly in a block. Block, crank, pistons, rods- all assembled and spinning. The Navi uses 4V heads, so there may be some timing chain issues that could affect the accessory positions and front engine dress. A better bet might be to go for a F-150 short block...
  6. Aaron 4.6

    1998 Mustang won't start after hybernation

    Corroded cables might not be getting enough amps through to turn the motor over.
  7. Aaron 4.6

    pullies a waste??

    just some guy- Congratulations for the stupidest post I have seen this year. It lacked focus, clarity, and relevance. That's akin to winning the Triple Crown. 1. Why are you talking about rotational mass? The product is called UNDERDRIVE pulleys, not LOWERED ROTATIONAL MASS pulleys. The...
  8. Aaron 4.6

    pullies a waste??

    This shouldn't even be a debate. Pulleys work. The physics are too simple to debate, and there are too many proven dyno runs to allow one or two examples to fly in the face of almost 10 years of data on the 4.6 motor. My own personal anecdote was at a dyno day in my old 99 GT. At the time it...
  9. Aaron 4.6

    Orange Headlight lense removal?

    click on the search button and type in 'clear corners' if that's not enough head to fnsweet.com for a detail write up
  10. Aaron 4.6

    Underdrive pullies

    Wow. Great tech in this thread guys. The pulleys will not give you an overheating problem. No reason to change them from that point-of-view. I have Steeda pulleys, and with the stereo blaring, at idle, with the headlights on, I also get some droop in the voltage needle. I'm running a single...
  11. Aaron 4.6

    need an alignment with new tires?

    Edges wear faster from turning. No alignment should be required.
  12. Aaron 4.6

    Ready to order the Gears-question

    Swapping 3.27s for 3.55s is like going to a nice restaurant and paying $50 for a hamburger and fries when you could have gotten lobster and steak for the exact same price. Sure you can do it, but you'd be an idiot.
  13. Aaron 4.6

    Need help w/tint???

    On a white car, 20% dark tint all around is the perfect choice.
  14. Aaron 4.6

    UCA/LCA questions...

    The control arms locate the axle. If you didn't have them the axle would fall out of the car. That's pretty simple. The job of the lower control arms is to push the car by transmitting force from the tires to the frame. However, this leaves the axle free to move side-to-side under cornering...
  15. Aaron 4.6

    Pros/Cons Ford Traction-Lok Differential

    A trac-lok, or a locker? Your thread title says one thing, and the post says another. Locker Pros: Best possible straight-line performance Locker Cons: Worst possible everything-else performance The biggest cost is some streetability. It will hook great at the drags, but you aren't going...
  16. Aaron 4.6

    How long are the stock spark plugs good for

    Well, since the stockers are platinums I would think you could get 100k+ out of them.
  17. Aaron 4.6

    Romeo or Windsor Built?

    Do as search if you really care. This has been discussed 1e+06 times. The short answer is it doesn't really matter.
  18. Aaron 4.6

    Romeo or Windsor Built?

    99/00 are the only Windsors.
  19. Aaron 4.6

    MM caster camber ?

    Well, the instructions tell you how to install the C/C plates, not align the car. You can lay masking tape down and mark the locations of the strut top before the install. If you position the strut top in the same place after install you should be fairly close. Close enough not to need to pay...
  20. Aaron 4.6

    Cobra Stalling, Sputtering Problem..help!!!!!

    Another vote for checking the fuel pump AND the fuel filter. Also, since your thread is not a really long book title you can relax the use of the 'shift' key when typing your posts...
View older results
Top Bottom
Back
Forums
Menu