Search results

  1. W

    Installing Raptor Shift Light (help needed)

    yes u have the ground and the power like u said and the 3rd wire goes into one of the "one of the 8 cylinders" . So u got that down pat. Take off the kick panel and u will see the 3 screws they tell u to take out to move the connectors. Then take the bolt out of the PCM harness and take the...
  2. W

    99 to 02 Mustang GT engine swap?

    actually the 2000's are windsor blocks as well 01 are romeo's
  3. W

    Best ways of getting power to the ground

    AS far as traction which most ppl haven't covered here it all depends on what u want out of ur stang. I recommend Maximum motorsports as well. Steeda is alittle pricy and there products don't seem to be as nice to me. Drag Car Full Length Tube Sub Frames Springs Shocks (QA1 or...
  4. W

    5w30 oil ok for 4.6?

    depending on where u live ford puts different labels on the mustang. If u live up north they put 5-20 if u live in the middle belt of states they typically put 5-30 and if u live down south they put 10-30. it all depends on where u live and the temps u have. so base it off where u live. For...
  5. W

    Chrome Altenators - What Brand Are You Running?

    I don't have the chrome one but I run a 200 amp PowerMaster
  6. W

    What's a good performing all-season tire for the stang?

    I would recommend if your looking for all season weather /snow in that size go with the BFG Gerforce KDWS, BridgeStone RE960AS Pole Position, or the BridgeStone RE92 Michelins are overpriced Kumhos just suck hardcore Goodyears are exactly what they say "good year" Falkens wear horribly...
  7. W

    Power steering pump or what?

    Since u did say u hit a pot hole most ppl will overlook somethings. Check your fluid level in your power steering resovior. if that is ok check your lines mainly the high pressure line but check the low as well. if those look good next check your rack and pinion. With the pothole u hit it...
  8. W

    Questions about changing/charging my AC..

    You will need a special tool to get those connections apart as for the accumulator u will have to replace it if u break a line anywhere due to the bag inside of it and moisture. Ur baest bet is to not worry bout it but if ur dead set on replacing it take it to a local shop and have the evac...
  9. W

    Why do brakes squeal if not bad?

    ok here is what to do it will take a little more time. but it will definatly help out and pretty much a 99% gaurantee that your brakes will stop squeaking Go To your local Auto parts store. You will need to pick up a couple things. You will need : Silicone Brake Lubricant (Paste type...
  10. W

    CERAMIC VS HTS HEADERS

    Its good for a while but its bulky and u have to consider as well as keeping heat in it can also retain more moisture between the two surfaces when cold.
  11. W

    Front brake pad recommendations???

    I have tried some quite a few pads and rotor combinations on my gt. The duralast and Wearever Pads both suck imo. The hawk pads are pretty good. But I recommend the Gran Sport GS5 or GS6 brake pads found on tirerack.com They are carbon-ceramic pads with very little dust and no noise...
  12. W

    E Brake??

    Wrong Ghost rider. The e-brake or "parking brake" which ever term u use is built into the rear calipers. That is why on a mustang u MUST turn the rear pistons to get them to go back in. They can be tightened to my knowlege. U need to look roughly under the center console with the car in the...
  13. W

    Trans problem or clutch problem, need help ASAP

    clutch cable
  14. W

    ROD KNOCK.......NEED HELP

    Gentlemen i think what he means is discontinuing the Windsor 4.6L in the Mustang and going to the romeo. In which case it could be true but i don't know that for a fact. My 4.6L Windsor from a 00GT spun a bearing as well with 77K so it could be possible.
  15. W

    Will this break my axles or differential???

    CORRECT!! ur right but unless a company is able to make a long lasting sticky tire which some have most of the sticky tires will be low tread wear.
  16. W

    stang "drained the snake"

    ok refill your system up with water don't bother added antifreeze now. leave the resovoir cap off and start your car. air bubbles in the system will get out if there are any. now a good way to tell if u have a stuck thermostat is to after bout 10 min put the cap back on and let it run for 5...
  17. W

    Which Idler Pulley?

    on the tensioner i would go ahead and replace the whole assembly. Tensioner will wear out and its better to spend a couple bucks more and get the whole thing than just the pulley.
  18. W

    New engine going in!

    if u have access to a lift it might be easier just to drop the trans and the motor at the same time and bring it out the bottom. just drop the K member and disconnect what u normally would and just have everything come out the bottom.
  19. W

    KC, Spec, or Ram?

    Mcleod or the centerforce Extreme DF not the standard DF
  20. W

    Tire and wheel fittment

    you will be good just make sure the rears have a 27mm backspacing on a 10.5" rim.
Top Bottom
Back
Forums
Menu